Recent content by jkyoho

  1. jkyoho

    Hardware Is the thermal pad on the battery charging chip necessary?

    I notice the 2R2 inductor next to BQ would heat up around 70C when playing&charging, not sure how BQ goes but the thermal pad definitely help
  2. jkyoho

    Picofly AIO Thread

    looks good. top side Extra gnd seems unnecessary though. The two square ground pads under cap could help stopping flex moving Around, I would say keep them.
  3. jkyoho

    Oled Volume Resistor

    doubt that's an inductor but not resistor. Based from OG and lite design, there are always 100~150 ohm resistor on buttons
  4. jkyoho

    Somewhat Confused here?

    delete cfw-syanad entry from hekate_ipl.ini and enable dns_mitmfrom day1, you should be 2steps away from dirty sysnand
  5. jkyoho

    Help Accidently blue screened my switch!!!

    file transfer can be done through Hekate(even from another switch). Boot 0/1 can be generated from emmchhaccgen on PC with prod.key from the Blue screen console. If you can't/don't know how to make unpatched switch into RCM mode, you are on your own.
  6. jkyoho

    Hardware Power supply problem

    Switch battery voltage max out at 4.23v-ish, 3.9v is pretty much closed to 90% charged, NOT VERY LOW. Also If you are expecting 15v goes into the battery terminal, I think you would see some popcorn out of your battery BMS board. This battery designated charging voltage is 4.35v max I believe...
  7. jkyoho

    Help Accidently blue screened my switch!!!

    So you are on HOS FW 18.0.0. Hekate 6.1.1 and AMS 1.7.0prelease should be able to support this verison. I believe you need to rebuild you nand using Tegraexplorer system_wipe to FW18.0.0
  8. jkyoho

    Help Accidently blue screened my switch!!!

    Did you download from Action or just the latest release on 2022 APRIL? Or you can post the system versions nca file name here like this
  9. jkyoho

    Hacking Hardware broke RST point pad on mi switch oled

    https://gbatemp.net/threads/striped-rst-point-pad-what-to-do.615729/ https://gbatemp.net/threads/b-point-issue-after-modding-switch-oled.634181/post-10178895
  10. jkyoho

    Picofly AIO Thread

    I would prefer solder point on back side in between 2 resistor so that the wiring wont seat on top of Nvidia base but outside of the edge
  11. jkyoho

    Picofly AIO Thread

    where is gate line should solder to? The front side rectangle ?
  12. jkyoho

    How can I restore clean NAND from a NAND backup with a lower version then the fuses?

    bottom line, if sysnand is clear why restore? Just keep it up to date if you want to online play anyway.
  13. jkyoho

    Switch OLED Capacitor/Resistor HELP

    0201 resistor; 0402 capacitor 6.3v should work
  14. jkyoho

    Switch OLED Capacitor/Resistor HELP

  15. jkyoho

    RP2040 Flex Pad came off is it B,C or somewhere else

    as long as D point has correct diode reading you are fine. The pad under D label on that resistor is ground point, and can be ignore
See more
General chit-chat
Help Users
  • No one is chatting at the moment.
    ZeroT21 @ ZeroT21: :lol: