Recent content by janjanp

  1. J

    Switch lite backlight doesn't work anymore

    Thank you, i checked it the ic seems not the same but there are 2 coils (4uH) and one coil (10uH). I was able to get a donor board from a V1, so I'll start testing with that.
  2. J

    Switch lite backlight doesn't work anymore

    Hello, I checked the datasheet of the TPS61163 ( https://www.ti.com/lit/ds/symlink/tps61163.pdf?ts=1749935057765 ). On page 19, it says that a 4.7 µH coil works for standard use. Do you think this kind of coil ( https://urlr.me/dYHNgP ) could work in a Switch Lite? Thank you.
  3. J

    Switch lite backlight doesn't work anymore

    Hello, I changed the FPC connector but the coil burned out, and I would like to replace it, but I don't know what type of coil it is. Do you know? Thank you.
  4. J

    Switch lite backlight doesn't work anymore

    Thank you for your reply. I received the flex cable and i have still not the backlight. I will buy and try to replace the 29 pin connector from the mainboard side. Indeed, I can't fully insert the cable into the connector on the right side, which could be due to a bent pin.
  5. J

    Switch lite backlight doesn't work anymore

    Hello, I tried to install a Picofly modchip on a Switch Lite. After finishing the chip installation, I reconnected the battery, but there was a burning smell and smoke coming from the Switch. I immediately unplugged the battery. I also completely removed the RP2040. When I reconnected and...
  6. J

    Switch V1, chip installation failed, and the console no longer charges the battery.

    Thank you very much i desolder the left cap with hot gun, clean pad and solder it again and its it's work !!
  7. J

    Switch V1, chip installation failed, and the console no longer charges the battery.

    Hello, I tried to install a modchip on a V1 Switch, but I messed up the GND point. As you can see in the photo, the three capacitors are bridged, and now the console no longer charges. I can still turn it on — there's 20% battery left — and the chip itself works fine (I connected GND to the USB...
  8. J

    I cut the line between clk and cpu on switch oled

    Hello everyone I wanted to install a picofly on my switch oled but I cut the link between clk and cpu Is there any way to save it ? Maybe remove the cpu and put a wire from cpu to clk point ? any other way ? ps : My pics arent good sorry I have a cheap microscope Thank you
  9. J

    Switch lite i removed the capacitor on 3.3v

    Yeah i don't have it, i should buy it a day I try with a 1uf 6.3v 0201 and it's work !! I hope it will ok a lof of time ! If you know what value of capicitor it is i would like to know it
  10. J

    Switch lite i removed the capacitor on 3.3v

    Hello, I tried to solder a Picofly chip onto a Switch Lite, but I messed up on the capacitor at the 3.3V point, and I accidentally desoldered it. I believe it’s a 0201-size capacitor, but I don’t know its value. If you could tell me what it is, I’d appreciate it. Does a 1 µF, 6.3 V capacitor in...
  11. J

    Switch OLED component value

    Thank you !!!
  12. J

    Switch OLED component value

    Hello everyone, I tried to solder the Picofly chip, but I messed up with the small component where the CMD is connected, and I desoldered it. Do you know which component it is, its value, and its size? I'd like to buy one to replace it. Thank You very MUCH !!!
See more