Recent content by Danid
-
D
Oled Kamikaze dat0 error *=* no emmc block 0
No tengo imagen, lo siento, ten en cuenta que si la has cortado y tienes el pad de 3ª capa o 4ª capa, puedes unirlo ya que es la misma. Puedes raspar más hacia el blindaje y encontrarás el Dat 0. I don't have an image, I'm sorry, note that if you have cut it and you have the 3rd layer or 4th...- Danid
- Post #15
- Forum: Nintendo Switch
-
D
Oled Kamikaze dat0 error *=* no emmc block 0
attached image to see- Danid
- Post #13
- Forum: Nintendo Switch
-
D
Oled Kamikaze dat0 error *=* no emmc block 0
finally you can discard this oled, uni layer 3 and 4, the 3 I had to scratch a little more inside until I managed to see it, I made a bridge between the 3 and the 4 and took the dat 0 towards picofly, everything perfect, it starts so much emunand like sysnand.- Danid
- Post #10
- Forum: Nintendo Switch
-
D
Oled Kamikaze dat0 error *=* no emmc block 0
The same thing happened to me, any solution? Apart from reaching the 4th layer which it shouldn't, in the third layer where the data is, part of it gives me its value but in the other part it is short. I think I have cut the dat 0 line, as I see that point on dat 0 reaches a point on the ram?- Danid
- Post #9
- Forum: Nintendo Switch
-
D
Stencils Reballing
Hello, I'm going crazy, buying stencils to reball the ic bq24193 and M92t36, now I have ordered a redmi note 9, because of iphone nothing, for the other ic if I have used iphone, but for these 2 ic I can't find it, If someone can tell me what model of mobile phone they have used, since the one...- Danid
- Thread
- Replies: 0
- Forum: Nintendo Switch
