Recent content by creesy

  1. creesy

    Hardware Help identifying component

    You are a legend. I searched high and low on Ali express! If I could hug you I would haha
  2. creesy

    Hacking OLED HWFLY Clone won't boot OFW?

    I actually think I am totally wrong about the firmware version. I think it's the ribbon cable that causes the issue and is why some consoles need 100ohm instead of 47ohm (it's caused by the ribbon cable) I've ordered some 100ohm resistors to test the theory. But I removed the A, D, 3.3v...
  3. creesy

    Hardware Help identifying component

    So today some idiot (me) was installing a modchip on a customer's OLED and didn't pay attention to where they were clamping the board (rookie error). So I manage to break what I think its an IC...which controls the docking and charging of the right joycon. I've seen it on a hand drawn...
  4. creesy

    Hacking OLED HWFLY Clone won't boot OFW?

    Thanks for the help! What's the preferred modchip now? I'm thinking about swapping my installs to intinctnx....seem to have a few issues with these clone type boards
  5. creesy

    Hacking OLED HWFLY Clone won't boot OFW?

    I've attached the photo of the board I'm using. I'm guessing it's the resistors next to the test points below the reset button? Do you know what size they are off the top of your head?
  6. creesy

    Hacking OLED HWFLY Clone won't boot OFW?

    Hey guys, Bit of an amatuer installer probably done 15 or so without issue. But this one is driving me mental, no matter what I try I can't get OFW to boot. Can create an emuMMC and boot CFW with not issues. Restart to OFW or power + volume -/+ gives me a Nintendo logo and then nothing but a...
See more