bvang913's latest activity
-
bvang913 replied to the thread OLED getting D0 error but I have correct diode voltage.Also good to share what kind of chip you have. An rp2040 zero/tiny or HWFly style. Edit: You said PCB so I'm guessing HWFly style. -
bvang913 reacted to superxoi's post in the thread Hacking Hardware Picofly - a HWFLY switch modchip with
Like.
Do the console boot without the chip? If not check the 3.3v rail if it is shorted or not. If it is not shorted check the voltage when you plug the power cable in to see if the 3.3v rail give you 3.3v or not. If it is not then check your 3.3v... -
bvang913 replied to the thread Would the HWFly v3 be enough to successfully mod an OLED Switch?.You need more than that. That is only the CPU flex cable. Looks like nothing else is included. If you go the HWFly route you're still missing several components needed. There's another flex cable that is soldered to points on the board as well as...
-
bvang913 replied to the thread Picofly AIO Thread.Advertisement Error code, short short = RST not connected. Check that point and what values are you reading in diode mode is what must people will tell you.
-
bvang913 replied to the thread Hacking eMMC RAW GPP backup after already using CFW.Yes still possible. Just boot back into Hekate to perform the backup. Shouldn't cause any problems.
-
bvang913 replied to the thread Hacking I have Switch Firmware 17.0.1, can I still hack it?.There are lots of resources out there. But also, I would recommend doing the research and having some soldering experience before even buying a chip. Good luck
-
bvang913 replied to the thread Hacking Hardware Picofly - a HWFLY switch modchip.Attaching pics of your install will help others in identifying what could be wrong.
-
bvang913 replied to the thread Hacking Hardware Switch OLED SkHynix with Picofly long boot-time.Probably 1-3 seconds. 0.2mm magnet wire from mosfet to drain and source, then 36awg from gate to tiny.
-
bvang913 replied to the thread Hacking Hardware Switch OLED SkHynix with Picofly long boot-time.Just did an OLED with SKHynix yesterday with single mosfet wired to the APU and Rp2040 Tiny. The first time powering up it just blinked blue for a very long time. So I held the power button down till it shut off, disconnected the battery then...
-
