Recent content by Belstone

  1. B

    Second Wind not starting on Switch

    FIXED: Second Wind won't work if the mod files are merged using the latest version of BCML (3.9.26). Downgrading to 3.9.24 fixes the problem. Run "pip install bcml==3.9.24" to downgrade to the working version.
  2. B

    Second Wind not starting on Switch

    Hi Guys. I'm trying to get Second Wind working on my newly chipped v1 Switch, but it always crashes upon launch with the message "The software was closed because an error occurred." I'm using an Hwfly to run Hekate and launch into Atmosphere (latest version). I have followed the guide...
  3. B

    Hacking Question tinfoil cannot open/install xci

    Thank you! I've spent the last several hours trying to install a BoTW .xci with Tinfoil via a LAN connection only to have it fail multiple times. I tried Awoo-Installer along with NS-usbloader and is copied over and installed in under ten minutes!
  4. B

    Consistent 2168-0002 error when installing/running Goldleaf and Tinfoil

    OK! It looks like it's working now. Impeeza was right- use a different guide. I started from scratch again and went through the following guides in this order: Backup the NAND before installing anything Set up Atmosphere with EmuNAND on Erista (SX Core / HWFLY) Install GoldLeaf Install...
  5. B

    Consistent 2168-0002 error when installing/running Goldleaf and Tinfoil

    Thanks. Is this for updating Atmosphere or even if installing for the first time? I'm trying again from scratch with a guide from your suggestions.
  6. B

    Consistent 2168-0002 error when installing/running Goldleaf and Tinfoil

    How do I do that? Could you please explain a bit about what the sys-modules are and do?
  7. B

    Consistent 2168-0002 error when installing/running Goldleaf and Tinfoil

    Hi All. I've just successfully installed a Hwfly (likely a clone) modchip into my v1 Switch. I've been following the video What after SWITCH Modchip Installation HWFLY - Guide [2022] to set up the software and SD card, I've and gotten up to 4:57 where Goldleaf is to be installed. However, I'm...
  8. B

    "Hello fellow forum members..."

    And now I need to post 5 times before I'm allowed to post a meaningful and informational request for help with a link to the guide that I've been using on Switch forum. Here's hoping...
  9. B

    "Hello fellow forum members..."

    Now I'm getting constant 2168-0002 errors when trying to install Goldleaf and Tinfoil...
  10. B

    "Hello fellow forum members..."

    Got the chip installed successfully. I kept having to re-attempt soldering onto that near-microscopic contact on the processor but finally got it.
  11. B

    "Hello fellow forum members..."

    Thank you both. The modchip arrived today so I'll be doing my research tonight. My biggest concerns in this project are avoiding bricking during setup and what to do about the Switch updating its firmware and/or preventing that.
  12. B

    "Hello fellow forum members..."

    Ok, old meme aside, I'm new here but I've lurked from time to time. I'm planning to modchip my old Switch v1 with a Hwfly (probably a clone) chip from Ali Express. I'll be doing the installation myself but I'm not sure how to proceed software-wise after that. Any help would be great! It's...
  13. B

    Hwfly on Switch v2.....and what to do next?

    Hey, are you still able to help? I've got a chip coming and will be doing the work myself. Any help would be appreciated.
See more