Yes I did. My guess is that the metadata that says which game is actually installed, is contained on the switch memory and not on the sdcard, which is why they’re not detected ?
Hi, I have a 200gb microsd card with EmuNand installed on it.
Today, I bought a new 400gb microsd card to replace my old 200gb microsd card.
I backuped the files from my 200gb card, then I installed SX EmuNand on the 400gb one, and finally I transfered the files back.
The issue is when my boot...
Hello,
I have a Switch on 6.2.0 using ChoiDuJour with AutoRCM enabled and running SXOS on my SysNand (in airplane mode since day 1).
I would like to install SX's EmuNand on my SD card, and then get a clean SysNand state, but I wanted to make sure that I don't forget a step:
1) Backup current...
But Hekate already has sleep/wake support (which is what @Lacius means by warmboot I assume?)
Also AutoRCM kinda allows untethered coldboot even if it is slightly unsafe.
And that post talks about 1.0-4.1, but what about 5.0+?
Hello, I have a Switch with firmware 5.0.0, I would like to backup my saves (in order to transfer them to another Switch, but later, let's say in a few weeks or months)
Is there any way to do this currently on 5.0.0?
Hekate + Checkpoint?
Thanks! I followed the guide and successfully downgraded!
I have one more question: if I wanted to use another SD card (a 64GB one) instead of the original SD card (4GB), what would be a good time to do it? Before starting Part 3 (rednand, luma, ..) of the guide?
Is there anything I should take...
New3DS XL on firmware 9.5.0-23E here.
I googled a lot and found pretty scary stories about the downgrade being unstable on N3DS and people bricking their consoles.
However the posts were 5 months old. What's the current status today?
How can I safely downgrade to 9.2?
Thanks!
Hello everyone!
I currently own a N3DS on firmware 10.7
I also have an O3DS 4.5 with Gateway and the latest emunand.
My plan is to use Gateway to install emunand on my N3DS, but after some hours googling I'm still a bit confused on how to proceed, and I would like to avoid doing stupid things...
I noticed some huge fps drops while trying to use drawImage.
10 images: 60 fps
20 images: 30 fps
40 images: 20 fps
etc.
I guess that's because it's drawing each pixel for each image.