Thanks, also I noticed you added some sort of tape to the nand. Is the nand supposed to be insulated?This is for Alex, enjoy.
View attachment 220975 View attachment 220976 View attachment 220977
Pm send
Max_034
Thanks, also I noticed you added some sort of tape to the nand. Is the nand supposed to be insulated?
Ah I see, better safe than sorry.I put kapton tape on exposed parts sx core and nand clip just the exposed test points, i'm exagerating with nand clip protection, and i covered the adezive remaing on nand clip with kapton to by easy to remove if is the case.
The easy and fast way is to put directly on last shield.
Ah I see, better safe than sorry.
Lite needs a microscope, besides that dont go with itWell, since I could not find any solution anywhere to the blank screen issue, I went on and ordered a new Lite.
Will there be a problem installing the same SX Lite on the new NS Lite?
I never got past the "boot.dat" screen on my (now "blind") first NS Lite.
Lite needs a microscope, besides that dont go with it
I' ve been messing with electronics since childhood ( in the '80s). Yes, everything is tiny on the Lite, but I managed to do it easily with a Hakko 926 soldering station and a Hakko 900 soldering iron that I have on my desk at this time. No microscope, no magnifying glass, no sweat.
It is quite easy, if you take your time. Everything worked as it should at first.
View attachment 221016
I assume that my fault was not thorougly isolating the chip module and/or the USB header of the debugging port. Something must have caused a short circuit when I assembled everything back together. I'll skip installing the USB port this time and cover the metal shield with insulating tape at the area over the SX Lite.
I' ll receive my new NS Lite tomorrow morning (in about 20 hours) . So I 'll post my results later on.
I hope that nothing was recorded on the SX Lite eeprom upon first boot on first the Lite, causing it not to work if I install it on my new Lite.
This is for CosXXX, enjoy.
Before your atempt.
View attachment 221019 View attachment 221020 View attachment 221021 View attachment 221022 View attachment 221023 View attachment 221024
After:
View attachment 221025 View attachment 221026 View attachment 221027
View attachment 221028
I noticed that my SX Lite seems different than yours (as seen on your last photo). Mine also has three letters printed onto it (Check my last posted photo).
Are there any clones around or there are different versions available?
Nice install manThis is for CosXXX, enjoy.
Before your atempt.
View attachment 221019 View attachment 221020 View attachment 221021 View attachment 221022 View attachment 221023 View attachment 221024
After:
View attachment 221025 View attachment 221026 View attachment 221027
View attachment 221028