Hacking Poll about error 00000019 and RealNand's FW version

[GeneralSmiley]

Tried the tape, no joy. As far as I can tell the solder looks fine as well or at least it looks like all the other pins. Also, be careful with the tape cause if you use too much its a bugger to get the thing out the slot again!

 

[suzumizu]

So... Still no fixes for error 00000019? Tape did not work, i'm not a solder guy so... anybody?

 

[gamesquest1]

Teensy.co.UK have kindly offered some faulty cards for me to take a look at, not sure what faults they will have but I will take a look if any have the 0000019 fault and see if there is any way to get past it

 

[Dust2dust]

Teensy.co.UK have kindly offered some faulty cards for me to take a look at, not sure what faults they will have but I will take a look if any have the 0000019 fault and see if there is any way to get past it

You can see you've got a solid reputation now, if a reseller asks you to check some stuff for them. Good luck with your findings. Everyone should be able to enjoy the new Omega 2.1 firmware.

 

[gamesquest1]

You can see you've got a solid reputation now, if a reseller asks you to check some stuff for them. Good luck with your findings. Everyone should be able to enjoy the new Omega 2.1 firmware.

Well tbh I did ask them if they had any faulty returns to look at, but they did say they had seen the stuff I was doing and wouldn't mind sending a few to have a look at.

Figured it would be good to try figure out what the faults where exactly I.e poor solder joint or something, figured it would be good for users who went with unofficial reseller and can't get a replacement

 

[JinbuKami]

Well tbh I did ask them if they had any faulty returns to look at, but they did say they had seen the stuff I was doing and wouldn't mind sending a few to have a look at.

Figured it would be good to try figure out what the faults where exactly I.e poor solder joint or something, figured it would be good for users who went with unofficial reseller and can't get a replacement

I highly doubt it has something to do with poor solder joints, but good luck,