I unlocked my V1 erista switch with a picofly but when I try to make a backup or create the emmc it gives me the following error "Your eMMC is initialized in slower mode" what do I do please help me
Later erista models were patched so the fusee gelee exploit didn't work.Just out of curiosity - why did you install a modchip in a V1 Erista?
Also V1?Later erista models were patched so the fusee gelee exploit didn't work.
Okay I thought there was Erista V1 (unpatched) and Erista V2 (patched). But I guess I have that wrong thenYes erista is v1
V2 is Mariko, better battery life modelOkay I thought there was Erista V1 (unpatched) and Erista V2 (patched). But I guess I have that wrong then
Unpatched model V1 supports the RCM method with either a jig or a chip such as the RCM-X86. For the novice user, then the jig is all you need along with an RCM Loader to boot into your custom firmware. Otherwise, for the V2 patched models, then a HWFLY chip is required. This shouldn't be your first, second or even third time with soldering. You must have plenty of experience before installing this chip, as there are very small points on the motherboard that you can accidentally bridge or pull off.Okay I thought there was Erista V1 (unpatched) and Erista V2 (patched). But I guess I have that wrong then
what are the Cmd and dat01 pls help me, I tried searching but I couldn't find it View attachment IMG20240224001802.jpgNo dont mess with the emmc, change your resistors on the modchip.
Cmd and dat01 to 100ohm.
This issue is in almost every thread and so is this advice.