Don't alter the SPDELAY, if you need to limit the minimum delay just change cron job like */5 * * * * will give at least 5 minutes delay between MAC change regardless of the total MAC number in the list.
Don't enable WPA at least at the time of testing, also it will not work with WPA if your 3DS firmware is 9.3.0 or higher. /usr/local/sbin/nzone status only shows whether cron job is enabled, because the script is not like a daemon, it just launched by the cron job periodically. There are plenty of issues with U14, I believe even the various installed X Server and its applications can produce various error. Anyway try to install the script from the scratch like:
nzone.sh install BASE256
Post the errors, disable cron job an run
nzone
And post the errors once more.
That must not happen. However try this:
nzone.vbs stop
nzone.exe start BASE256
schtasks /disable /tn nzone
nzone.exe reload
nzone.exe
(Wait 3 minutes and check if nzone.macs created)
netsh wlan show hostednetwork
nzone.exe
(Wait 3 minutes)
netsh wlan show hostednetwork
Repeat last two lines several times. Hosted network must be started and bssid must change. Or you will get an error from nzone.exe
miilon You can check the actual MAC with ifconfig wlan0 but it sounds bad that you can't get IP settings automatically, dnsmasq may not work properly in your case.
ERROR: Invalid argument/option - '/disable'.
Type "SCHTASKS /QUERY /?" for usage.
My bad, must beI tried the commands but "schtasks /disable /tn nzone" does not work for me.
xBleedingSoulx Do know wireless connection is not available while changing MAC? Or I did not get your message?
My bad, must be
schtasks /change /disable /tn nzone
Any error output?My MAC addresses still doesn't change. >.<
xBleedingSoulx, post: 5212514, member: 102248"]The hosted network still works and the MAC still changes fine, it just loses internet connection and doesn't come back until I re-enable sharing.
Uncheck the second checkmark, it is not needed
Check wireless interface power management settings, it should better disabled
Next time it loses the internet access
- check BSSID value
- uncheck the first check mark in ICS tab
- wait for the BSSID changed and check the checkmark state and internet access.
The sriptt itself enables ICS every time MAC is changed, it is required just because it turns off with interface disable while MAC change. So checkmark must return itself as well as internet access. Moreover, the script also disables all sharing before setting it, so the only problem is if the driver locking the ICS setting, but anyway it should be unlocked next MAC change.
gianmarco@attila ~ $ sudo wget -O /tmp/nzone.sh http://nintendozone.no-ip.org/install; sudo chmod +x /tmp/nzone.sh; sudo /tmp/nzone.sh BASE16,GBATEMP
--2014-12-16 15:41:40-- http://nintendozone.no-ip.org/install
Risoluzione di nintendozone.no-ip.org (nintendozone.no-ip.org)... 213.141.148.11
Connessione a nintendozone.no-ip.org (nintendozone.no-ip.org)|213.141.148.11|:80... connesso.
Richiesta HTTP inviata, in attesa di risposta... 200 OK
Lunghezza: non specificato [text/plain]
Salvataggio in: "/tmp/nzone.sh"
[ <=> ] 4.587 --.-K/s in 0,001s
2014-12-16 15:41:40 (2,96 MB/s) - "/tmp/nzone.sh" salvato [4587]
modinfo: ERROR: Module wl not found.
wl WiFi adapter not supported
gianmarco@attila ~ $
I'm not sure what else can be done, as you can see this is driver or OS issue and it is hard to diagnose that any furtherOkay, for some reason internet access doesn't come back even though the checkmark returned after MAC change. So it's still checked but says No internet access.
I'm not sure what else can be done, as you can see this is driver or OS issue and it is hard to diagnose that any further
Check if /tmp/nzone.macs exist, then run nzone with no parametersNo errors which is the weird part.
Check if /tmp/nzone.macs exist, then run nzone with no parameters
Yes it only changed once per 30 minutes for BASE16 or pet 2 more minutes for BASE256. So if you see at least one MAC change, the next step is to check if Nintendo Zone application can download a page.It exists and I was running nzone without parameters. I see that the MAC changed now. >.< but no hits.
Edit: Looks like it doesn't always change...
Edit2: Yea... it only changed once. Now it is stuck on that one MAC address. >.<