Nice one bud
🤟😎🤟
1700470495
Is it OLED?
I would go straight to the DAT0 adaptor if so.
I've not seen this on a V1/V2, but others might have for some reason.
No
I'm talking about OLED, read the post.
I've not had an issue still & I'm helping the guy.
We all have independant experiences & opinions, so you shouldn't be talking to strangers that way either.
Any further agressive replies will be ignored.
I've seen this with a few cowboy fixes I've had to do.
The DAT0 is sitting partially on DAT1, with the crappy OATO adaptors the silk screen is either off center, or the DAT0 pin connector is a 'C' kind of look and not a 'u'... sometimes the C connection touches the side of DAT1.
I'd pull it...
Anybody tried chipping an already updated 17.0.0 ??
I bought two last night and were already on it.
Installed the chips and both oled consoles reach glitch limit. Odd.
Never had a problem up until now.
Just offset the adaptor on install to the right hand side so it's between an unused BGA ball and DAT0.
The left hand alignment screenprint on adaptor should not be seen and the right hand one will be past the chip by a mm or so.
No returns still my end! Lol
On
Only time I've seen slow mode is a dat0 short with dat1.
Another modders fault sent to me.
Problem was on taking the chip out all he had was a pink screen on boot.
Report was it was crashing in OFW before - so corruption due to poorly installed dat0 adaptor.
I had to take out the old...
Jesus, this is what I end up with.... ready to be soldered to.
I would say to the bad modders that you should be treating each console as your own.
A bit of respect 😎👍
1689619284
This is it... how do we repay him?
If you can't do it, send it to me.
Done a few oled connectors now.
People have come to me in emergency via this forum to help.
I'm in Surrey.
Ant
1689446923
@rehius
Do you have a donation link?
I paid my last months rent off selling chipped Switches... this is the least I can do for your...
This is the sort of times I get with all my modded OLEDs I sell.
I have been covering my smallest soldered points with uv activated pcb resist however.
Maybe this is limiting interference?
since i doubled up, or you lost your stack and if i gave it to you instead of running off at the roulette table does that mean i "gave" you a stack lol