Search results

  1. P

    Hacking Installers in the UK

    Can you message me I have a question.
  2. P

    Hacking Sx Core and Sx Lite , test Units Received

    I have 6 of them sitting on my desk, I ordered 20 of them and fitted 14 of them in tablet only switches and sold them on Facebook market place. Ran out of switch tablets so they have just been sitting there.
  3. P

    Hacking Sx Core and Sx Lite , test Units Received

    Are these not avalible anymore ? Saw one sell on eBay UK for £100
  4. P

    Hardware Rapid Blinking Led Switch Dock

    I bring good news. I am guessing the PI3USB wasn't getting the voltage it needed as I have just changed the M92T36 IC and we are back in action, tablet and docked mode now both working.
  5. P

    Hardware Rapid Blinking Led Switch Dock

    Hello all, Got a faulty Switch that no matter what dock I put it in I get a flashing green LED. I can't find any shorts on the board. It turns on, charges and works fine Handheld. I have tried: New USB C port (checked and I have continuity on both edges of the connector) New PI3USB IC...
  6. P

    SX Core/Lite online purchase

    Would appreciate a link for a UK / China supplier if anyone above be kind enough to send me a PM. Cheers
  7. P

    Hardware Black Screen issue after replacing BQ Chip

    I will need to check, I gave up for a bit with it as I had other things to repair, will take a look tomorrow. I have noticed that the following happens. Connect via a USB hub to charge it takes 0.5a Battery logo shows and doesn't seem to charge and as soon as I remove power it dies Put a...
  8. P

    Hardware Black Screen issue after replacing BQ Chip

    Not got into the software side of things will have a look in the morning. Thanks Yeah when I had it under the lamp today I noticed the colour difference between the two and realised they weren't in fact caps. However lifting the board back out, I checked a few of the caps on the rear under...
  9. P

    Hardware Black Screen issue after replacing BQ Chip

    Tried two batteries one known to be working :(
  10. P

    Hardware Black Screen issue after replacing BQ Chip

    Was just checking voltages I'm getting 4v to the Backlight ribbon but it's not lighting up.
  11. P

    Hardware Black Screen issue after replacing BQ Chip

    Hi All, I bought a faulty switch that had a cracked screen and also didn't turn on. Opened it up to check for short and to transplant it into a housing that had a good LCD etc. All the caps around the BQ and some around the M9 chip had shorted, checking with a voltmeter it wasn't drawing...
  12. P

    Hardware 2DS appears to charge but doesn't

    Hi All, Have a Pokemon 2DS that just flashed red when you tried to use it, so I assumed it was the battery. The battery was replaced but it does the same it will turn on for 30 seconds flash red and then die. When I run it off the mains it works absolutely fine so I am assuming the charging...
  13. P

    Hardware Neither Joycon charges when attached to switch

    I have swapped them out for new working ones and the issue is still present. I have ordered both the ICs that control the USB and Charging. Replaced one, but I have damaged the connector for the LCD flex -___- 1 pin has slip out of place so I have ordered a new connector to replace it with. Will...
  14. P

    Hardware Neither Joycon charges when attached to switch

    Tried new rails this didn't make a difference :(
  15. P

    Hardware Neither Joycon charges when attached to switch

    @Borega are these the values I should be expecting ? Regards
  16. P

    Hardware Neither Joycon charges when attached to switch

    So on each side of the console I am getting 1.79v going to the joycons whilst connected to the AC adapter, on the little resister that is inline with the connector for the left joycon that is only getting 0.6v across it. The rails are good, the switch detects them just not charging, I have...
  17. P

    Hardware 3DS turning off while closing it?

    If it has ever taken a fall sounds like it is a lose top LCD ribbon cable.
  18. P

    Hardware Neither Joycon charges when attached to switch

    Shall do, not round to doing it yet.
  19. P

    Hardware Neither Joycon charges when attached to switch

    Will do some probing later today, I think I have a couple spare BQ chips I can drop on and test. Thanks I have a few sets of Joy Cons and they are all the same on the problem switch. Put them in a working switch and they behave as normal. Thanks
  20. P

    Hardware Neither Joycon charges when attached to switch

    Yeah switch does charge. Just no lightning bolt on the joycons.
General chit-chat
Help Users
  • No one is chatting at the moment.
    OctoAori20 @ OctoAori20: Nice nice-