Recent content by zumbito

  1. Z

    OLED Switch “A” CMD Resistor - Half Damaged Pad

    Hi, interested in this. Are they 4.7 or 47?
  2. Z

    Switch not turning on

    I have only touched three parts, and they all seem fine. This is really nerve wrecking.
  3. Z

    Pico fly. How to know if I screed an APU Cap?

    I haven't touch any other traces, not sure what to look for...
  4. Z

    Pico fly. How to know if I screed an APU Cap?

    So this time I went step by trying to install the picofly and the switch is not turning on" Step 1 I installed the APU cable, switch turned on. Step 2 Kamikaze drilled, Found Dat0, measurement correct, masked the hole, switch turned on. Went for lunch Step 3. Soldered a cable to dat0...
  5. Z

    Should this point be grounded?

    Hi, I think I have the same issue, but the link doesn't work.
  6. Z

    0.3 in the DAT0 adapter Switch oled.

    Sorry but where? The Ribbon goes directly under the emmc.
  7. Z

    0.3 in the DAT0 adapter Switch oled.

    So I was installing my Dat0 cable and got some decent 0.54 v reading. I assembled everything to check if it was working... And got nothing front he switch. I measured voltages and now Dat0 reads 0.3, isn't that too low? I am trying to resit the cable but I am not getting anything different. Any...
  8. Z

    Switch not turning on

    So after a failed Picofly install, I decided to remove the flex cables, resulting in the switch not turning on. A couple caps from the APU disappeared in the process of removing the cable and habe orders some. While I wait for the caps to be delivered, any tips of where or how to start? Maybe...
  9. Z

    Hardware What is the capacitor value on top of Nintendo Switch APU?

    Interested in this. How do I measure these with the multimeter to check if they are good? Continuity? Diode? Ohms?
  10. Z

    Picofly Switch not starting anymore

    Hi, I am having the same issue. What do you mean by reflowing the eMMC?
  11. Z

    [mainly about Germany] in search of an good and cheap place to solder a pico fly

    From Spain, living in Munich. Can you ask him for rates?
  12. Z

    [mainly about Germany] in search of an good and cheap place to solder a pico fly

    Hi, would you mind sharing the Munich one?
See more