Recent content by unchil

  1. U

    Hacking Hardware Picofly - a HWFLY switch modchip

    Even if my diode mode value is ok?
  2. U

    Hacking Hardware Picofly - a HWFLY switch modchip

    My pico in oled shows =*== error - emmc test faliure, read failed. Console boots to normal os. My diode mode values looks like below 0.614 dat0 0.68 cmd 0.73 clk 1.5 rst 0,62 cpu Every connnection and every resistor looks ok. Emmc adapter looks like on the photo. Where can I look for the problem?
  3. U

    Hacking Hardware Picofly - a HWFLY switch modchip

    Now pico starts ok but it gives me en error =*== emmc test faliure - read failed
  4. U

    Hacking Hardware Picofly - a HWFLY switch modchip

    holy... This was so obvious... Thanks
  5. U

    Hacking Hardware Picofly - a HWFLY switch modchip

    I installed pico rp2040 on my oled. Every connection looks ok but it doesnt work. Im getting 2 short blinks (rst not connected error) and it boots to normal os. Rst point has 1,5 value in diode mode test if its connected to pico. Without conection is 2.7. Also pico starts right after connecting...
  6. U

    Hacking Hardware Picofly - a HWFLY switch modchip

    no, its v1 *=* No eMMC block 0 read (eMMC init failure?) So it looks like my eMMC is fckd? Can I buy it from aliexpress (whole module with connector) and try to restore it? EDIT: EDIT 2: I created emuemmc. When I`m trying to boot emu I`m getting en error: "error while loading fss0...
  7. U

    Hacking Hardware Picofly - a HWFLY switch modchip

    What does *=* blink mean? I cant find info about it. My switch doesnt start with or without chip right now. Black screen.
  8. U

    Hacking Hardware Picofly - a HWFLY switch modchip

    I have a patched v1. I installed a pico but i couldn`t boot to the system. It was showing hekate loading bar and then black screen. I removed the chip and now I have a black screen. There is voltage on the cpu when i push the pwr button. Did I broke the emmc? How can I check if? What can I try...
  9. U

    Hacking Hardware Picofly - a HWFLY switch modchip

    Has anyone had a similar problem?
  10. U

    Hacking Hardware Picofly - a HWFLY switch modchip

    I have a similar problem, new pico install, and =*** flashes. I read 1.79v on dat0. =* when d0 is disconnected. v2.74 I am using v1 flex
See more