Recent content by Tom_

  1. Tom_

    Hacking Hardware Picofly - a HWFLY switch modchip

    Yeah! Switch (OLED with SK Hynix) came back to life! Solution after purple screen: - replace CMD resistor - added 550R on DAT0 (47R CMD, 47R CLK) - GPP restore from backup Boot to hekate and boot to OFW now possible. Glitchingtimes with 550R much faster than with 47R or 100R Thanks for help!
  2. Tom_

    Hacking Hardware Picofly - a HWFLY switch modchip

    I´m sorry, but I couldn´t tell because eMMC didn´t init. Now I tried with 550R and eMMC could be init in hekate. eMMC info shows GPP (emmc user): Partition table is empty. Does it help to restore from my backup? Do I need to restore full RAW GPP?
  3. Tom_

    Hacking Hardware Picofly - a HWFLY switch modchip

    I tried Instinct V6S, but with the same result: purple screen on OFW, emmc init failed with 5 retries. Although tried the instinct v6s with additional 220R on DAT0 and tried picofly with 47R+220R (Waveshare tiny) on DAT0. Everytime with same result. replaced the CMD resistor the fourth time...
  4. Tom_

    Hacking Hardware Picofly - a HWFLY switch modchip

    I know this thread. As I said before, I changed the resistor several times without success. If it is only he resistor, I thought hekate must be able to init emmc? And how can I find out if it is a bad gpt andhow to fix it?
  5. Tom_

    Hacking Hardware Picofly - a HWFLY switch modchip

    yes, already tried. But the problem is the boot to OFW. Even when I desolder the picofly completly, there is a purple screen on boot.
  6. Tom_

    Hacking Hardware Picofly - a HWFLY switch modchip

    Picofly works, No SD Card is shown on boot up. Glitch works. But if I try to boot to OFW (from hekate oder direkt while pressing VOL+/- on boot) I get a purple screen. emmc info says that init fails. init retry count is 10. I´ve only Instinct V6S chip here. Will it work although?
  7. Tom_

    Hacking Hardware Picofly - a HWFLY switch modchip

    hmm now i have error message "failed to init eMMC". I know that worked before, because I had made an complete nand backup. Any ideas why there is a emmc error? i have a waveshare tiny with added 51 ohm to cmd and DAT0. multimeter verified.
  8. Tom_

    Hacking Hardware Picofly - a HWFLY switch modchip

    I´ve the same problem with my OLED. With everything soldered (picofly, mosfet back install, DAT0 flex adapter), I can boot to hekate and start payloads (CFW and others). Starting OFW results direct in a purple screen. swapping the 4.7k resistor with a new one (tried it three times) and...
  9. Tom_

    Swapping boards with nand backup

    Hi all! Can someone tell me if it is posible to swap to boards (oled) with nand backup and restore on another board from the other? Is it fully compatible (serial nummer, online play etc). Thanks, Tom
  10. Tom_

    Hacking Hardware Picofly - a HWFLY switch modchip

    Hi all, but how can I clean the flux on reballing? Greetz, Tom
See more