Recent content by thebroodian

  1. T

    picofly black screen with sd card / no card sd screen without card

    Your A points and D points are bridged. Difficult to tell if your SP1 point is attached at all
  2. T

    Hacking Killed a motherboard doing kamikaze method

    1729888568 Can you elaborate a little more about what trace I cut? I don't think I cut any trace, the diode reading on the point still reads normal. Edit: nevermind, you were right. I revealed more of the trace, and repaired it, and tested. Switch came right to life! 1729890251 Thanks to...
  3. T

    Hacking Killed a motherboard doing kamikaze method

    I was working on a modchip installation - the system turned on after I finished grinding down to the dat0 point. I was having a very hard time getting solder to bind to the dat0 point, I was having to clean and retry, and clean and retry. Eventually, I had been working on it for quite a while to...
  4. T

    Hardware Modding service recommendation

    Hi! I do modding in the US. You can check my shop for customer testimonies here: ebay dot com slash usr slash warrior_dragon
  5. T

    Switch Lite SD card reader issue

    Would you happen to have any idea what is responsible on the switch lite for raising the enable pin?
  6. T

    Switch Lite SD card reader issue

    I installed a picofly into a switch lite, and the modchip appears to work, screen goes to the expected raspberry pi logo "No SD Card" screen, excellent. However, I then discovered that the SD Card reader doesn't read any card at all. The OFW also doesn't throw any error codes or anything like...
  7. T

    Switch Lite Picofly error code =*** eMMC init failure

    Hi all, I'm struggling to troubleshoot a picofly install on a switch lite. This is my first picofly install on a switch lite, but I've succeeded with installations on standard switches. I believe that I've done the installation correctly, but it's giving me the 'long, short, short, short'...
  8. T

    Hacking Hardware Picofly Error Code Issues - Switch Lite

    At the time when you were having this issue, did the flex cable have continuity from c at the EMMC and c on the chip?
See more