Recent content by Spadra27

  1. S

    Hacking Plailect Guide Part 5, Section VI, Step 9 - FBI loads Health and Safety Information

    Hi KunoichiZ! Thank you for the advice. I am happy to report it worked and I am now running A9LH!
  2. S

    Hacking Plailect Guide Part 5, Section VI, Step 9 - FBI loads Health and Safety Information

    Hello All, Thanks for reading. I am almost done setting up A9LH on my 3DS. I am up to the step in Part 5 section VI in which you use FBI to load several CIAs. Unfortunately my FBI loads the Health and Safety Information screen after updating version. Do I need to place Decrypt9 back on the SD...
  3. S

    Hacking REDnand boot failure - Luma issue?

    MAJOR UPDATE! On my hunch I started searching for threads based on Gateway and Luma compatibility issues. Turns out there are quite a few. I attempted the CIA fix from the Luma FAQ and I can NOW load into RedNAND. Should anyone else be following this because they are experiencing the same...
  4. S

    Hacking REDnand boot failure - Luma issue?

    Thanks Tenshi, unfortunately after using Tiny I am unable to boot into Homebrew through the web/QR code exploit. I assumed I may have over done the sequencing. So I grabbed the older 2GB SD, cleared it setup up with the start kit files and began from step 1. I have managed to get back into Part...
  5. S

    Hacking REDnand boot failure - Luma issue?

    Hi All, I have attempted to play around with the config. I can confirm in EmuNAND that my /emuNAND directory is populated with a RedNAND. Which is great but Luma is freezing on the config screen and Cake loads into the homepage BUT the version does not reflect EMU. Still have some things to...
  6. S

    Hacking REDnand boot failure - Luma issue?

    Thanks KunoichiZ, I agree I should definitely do that to distinguish between the two. My concern is at the moment Luma boots into a home screen which does not display the EMU for the version. I am not sure IF that is technically the Red or SysNAND. Once I can determine different themes will be...
  7. S

    Hacking REDnand boot failure - Luma issue?

    Gkoelho, That clears up my confusion. Thank you for the explanation! My question now would be how to distinguish between the two or go through EmuNAND9 and assign one to cold boot? On my last run through the installation process I noticed I have REDNAND installed but Luma boots into what I am...
  8. S

    Hacking REDnand boot failure - Luma issue?

    I would appreciate hearing how you set it up. My update is after completing a format on the SD card and running through the Plailect guide from Part1 I still had the same result. I just installed Cake but noticed the options are obviously different. Thanks everyone for all your input!
  9. S

    Hacking REDnand boot failure - Luma issue?

    UPDATE: Formatted the card and I am ready to Complete RedNAND Setup. I noticed that when I initiate the process the first line says "File starter.bin was not found continuing without autosetup..." I can still opt to continue the process. Is this my red flag??
  10. S

    Hacking REDnand boot failure - Luma issue?

    Hi gkoelho, thanks for joining the discussion. I am fairly sure I am not in RedNAND/EmuNAND. It was my understanding the menuhax config for booting into Homebrew was dependent on you being in SysNAND. Or am I misinterpreting CFW and your question?
  11. S

    Hacking REDnand boot failure - Luma issue?

    I only have access to a Mac... Is this a known issue?
  12. S

    Hacking REDnand boot failure - Luma issue?

    I will definitely give this a shot. For clarification - For formatting the card can I do this on a Mac? Set to 32FAT? Or were you referring to formatting in Homebrew? - Once the card is formatted where do I pick the guide up from? part1?
  13. S

    Hacking REDnand boot failure - Luma issue?

    Same result. Black screens on Luma reboot.
  14. S

    Hacking REDnand boot failure - Luma issue?

    I will give that a try. I have conducted the Complete RedNAND Setup several times. Should I remove RedNAND prior? Will it overwrite the existing Red or create a second one? Starting to wonder if there is a duplicity issue... I also saw this Should this be something to consider? What version...
  15. S

    Hacking REDnand boot failure - Luma issue?

    I have tried with the 2GB the unit came with and an upgraded 64GB SD that was formatted to 32FAT. For the EmuNAND/RedNAND formatting what would be the proper procedure? Assuming I would be using EmuNAND9?
See more