Recent content by redditorguy

  1. redditorguy

    switch lite not turning on after hwfly install

    no i did not yes checked with multi meter and everything seemed to in it place but was just too tired to redo so took it all off and swtich turned back on
  2. redditorguy

    switch lite not turning on after hwfly install

    so installed it, the chip doesnt show any leds and console not turning on! took all wires out and console is back up running again. not gona go back soldering this s%#$ chip again but curios to know what went wrong?
  3. redditorguy

    help with finding switch lite alternative 3.5v pin to install hwfly 4

    thanks heaps are these the only two points? looking for bigger one :D
  4. redditorguy

    help with finding switch lite alternative 3.5v pin to install hwfly 4

    could you please send a picture of the micro sd cap ? thankjs
  5. redditorguy

    help with finding switch lite alternative 3.5v pin to install hwfly 4

    hi please assist trying to solder following with wire skipping the flex cable as had some issues, is there like alternative 3.3.v pin around the board rather than that one as it is very tiny for my wire ? thanks
  6. redditorguy

    installing hwfly 4.1 on switch lite please help ! chip not attaching

    thanks we tested the ribbon cable with multimeter and still works phew, if we directly wire it do we need to do anything for the grounding?
  7. redditorguy

    installing hwfly 4.1 on switch lite please help ! chip not attaching

    what are you recommendation ? my friend who is experinced with micro soldering was using the chisel type
  8. redditorguy

    installing hwfly 4.1 on switch lite please help ! chip not attaching

    oh like getting slim wires from the console and attaching it there? thats a good idea! Thanks good idea. it just because i took it off and on few times as i was struggling installing it :( yes doing that using flux , we managed to solder the first part but this one is struggle !
  9. redditorguy

    installing hwfly 4.1 on switch lite please help ! chip not attaching

    thats the chip what solder iron tip did you use? also do i need to cut that part chip
  10. redditorguy

    installing hwfly 4.1 on switch lite please help ! chip not attaching

    Ok please help. first thing i have recieved info to cut part of this chip do i have to do it? 2nd question we having hard time to solder A and C and D points due to lack of copper any tips please? im getting my friend help as well who is experienced with soldering but still we cant solder it...
See more