Recent content by RathX

  1. RathX

    Hardware Fix broken Switch? It's not turning on and also not charging

    I'm not sure, should've checked better :D I'll order M92 and some chokes and fuses, hopefully the problem will be fixed! I don't get it how it died, but whatever I guess. Thank you all for your help, I'll update after changing the parts.
  2. RathX

    Hardware Fix broken Switch? It's not turning on and also not charging

    Oh sorry, forgot to mention that part. It's 0.75V on both points 2 and 3
  3. RathX

    Hardware Fix broken Switch? It's not turning on and also not charging

    Oh okay thank you! Diode mode with red on ground + pad 2 and 3 reads 0.755V for both. I think I've measured on the wrong points all the time until now, is the marked spot correct on the picture? Because now I've got the right voltage I think 1.5V, 2.8V, 1.5V on pins 38-39-40. The tip with...
  4. RathX

    Hardware Fix broken Switch? It's not turning on and also not charging

    Ok, I've applied some flux around the ESD, and made sure everything is clean, maybe some point was connected to the shielding right next to the ESD, but now I measure the pins like on the picture. No shorting to ground on D+ and D-. Connecting to PC still doesn't show anything in TegraRCM...
  5. RathX

    Hardware Fix broken Switch? It's not turning on and also not charging

    Ok, got me a better multimeter today. Is there a certain spot where is should be measuring for the M24 pins? I've always held one contact on the positive battery pin. So it's weird with pin 5&6, since the voltages change wether I connect to the cathode or anode pin on the battery slot. Result...
  6. RathX

    Hardware Fix broken Switch? It's not turning on and also not charging

    That's a lot of information, thank you! The USB Port looks fine to me, couldn't see any bent pins. On M92 I've measured ~4.5V on pins 5&9, but around 0V on pin 6. I've checked the blue marked cap (see picture: blue circle), but there is no short, seems to be okay. -> Does this mean M92 is...
  7. RathX

    Hardware Fix broken Switch? It's not turning on and also not charging

    Oh it does beep, so all good with the coil I assume
  8. RathX

    Hardware Fix broken Switch? It's not turning on and also not charging

    I've went ahead and did the blob solder, there is a ~5V current between the blob and the battery slot when plugging in USB.. I guess a new fuse would be needed now, do you know what the part is called? I don't know if it should've fixed the issue, but the switch still isn't turning on. :/ I...
  9. RathX

    Hardware Fix broken Switch? It's not turning on and also not charging

    Hey I hope I can find some help here, I'm really frustrated and can't find any solution to my problem. A few things to know, The switch has AutoRCM enabled An RCMx86 chip was soldered, but even after desoldering the switch doesn't work (Everything worked fine, before the problem happened) The...
  10. RathX

    Tutorial PS4 Exploit Guide

    @KiiWii Do you know any way of updating from 5.05 to 6.72 with the noBD method?
  11. RathX

    Tutorial How to setup Atmosphere EmuMMC

    I've installed SX OS as "Files on SD" and got SwitchBoot_UF2 chip with multi-NAND option. Can I somehow create a parallel EmuNAND launcher, which uses Emutendo as storage in Atmosphere?
See more
General chit-chat
Help Users
  • No one is chatting at the moment.
    BakerMan @ BakerMan: @salazarcosplay yeah cod's still up