Recent content by radialblur

  1. radialblur

    Switch OLED missing the CMD capacitor

    Could anyone let me know if this is the correct component for the CMD replacement please? https://uk.farnell.com/yageo/rc0201fr-074k7l/res-4k7-1-0-05w-0201-thick-film/dp/1857004
  2. radialblur

    Switch OLED missing the CMD capacitor

    Thank you for the input guys, before I tried to put it back on I checked it with my multimeter and it appears to be cooked as getting no value out of it, would someone be kind enough to point me to the exact part I need please? I am very much a rookie with all of this but I am trying to learn as...
  3. radialblur

    Switch OLED missing the CMD capacitor

    So can go either way around?
  4. radialblur

    Switch OLED missing the CMD capacitor

    I lifted mine too, still have it though, is there a correct orientation to put it back on?
  5. radialblur

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Hi all, in need of a little advice... Is my trinket a brick? I followed the software guide, got part 1 and 2 UF2 files and put the m0 in to updater mode (drivers installed) the drive mounted fine and I dropped FUSEE_SUITE_TRINKET.uf2 on to the unit... it rebooted, put in to update mode and...
  6. radialblur

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Question relating to wire used, I've read the FAQ and seen the suggestions, can anyone comment if "30 Gauge Silicone Wire" is OK please? Specifically this stuff: B077GQQXRY on Amazon UK. (sorry can't post a link, forum thinks its spam) I know the OP mentioned getting Kynar covered, however I'm...
  7. radialblur

    Hacking Switch on 3.0.2, Update advice needed please...

    You're a star, thank you :) Yep, up to speed with TX and the delays, 7.0.1 should be fine for a little while, assuming I can use Goldleaf to sidestep most imposed updates for the time being when loading XCI's? Just before I go do this, can I just confirm that I am OK to boot the Switch for...
  8. radialblur

    Hacking Switch on 3.0.2, Update advice needed please...

    Thanks dude, appreciate the input, seems we posted at exactly the same time as I edited my second post with a quote/reply... :) Reading between the lines I guess I am OK not to use AutoRCM and do the backup, then proceed with Emunand. Fully understand the ban status etc, just wanted to make...
  9. radialblur

    Hacking Switch on 3.0.2, Update advice needed please...

    Thank you for the reply @Hayato213 just to clear up a couple of things and to make sure I do this right... AutoRCM, is it OK to use these days? Are there still issues if the battery runs down? Does enabling AutoRCM make any changes to SysNAND? I would like to get a clean backup first so...
  10. radialblur

    Hacking Switch on 3.0.2, Update advice needed please...

    Hi All, So I have a brand new Switch that's been in its box since I bought it ~10 months ago, the only thing I did was boot in to maintenance mode to check firmware (3.0.2) and check the serial number (it's safe apparently) Recently a friend gave me an SX Pro dongle & license, so where should...
See more
General chit-chat
Help Users
    S @ salazarcosplay: hi @AncientBoi +1