Recent content by popgenie

  1. popgenie

    1-bit mode on Hekate - Please Help

    Thanks for everyone’s help again. It has been fixed now! I took out the board and measured the FPC connector. The DAT2 is no longer connected to the ground. I’m not sure what caused this, but I have the following observations from when I took the main board out: One of the antennas was not...
  2. popgenie

    1-bit mode on Hekate - Please Help

    You are right ! But now they connected to ground, that's the issue.
  3. popgenie

    1-bit mode on Hekate - Please Help

    Thanks for everyone's help. It is RCM MOD. How to measure the resistor value for cmd, clk, d0? I tired to replace a new SD connection board, it still have the same issue. The FPC connector looks clean and no pins are loosing. From the picture, I measured both blue point connected to GND. :unsure:
  4. popgenie

    1-bit mode on Hekate - Please Help

    Yes, it connected to the black label point on the left, but it also connected to the GND. :unsure: I tried the other SNS, DAT0, DAT3, DAT1, CLK and CMD which none of them connected to the GND. I'm trying to figure out why this happened and looking for a fix, thanks.
  5. popgenie

    1-bit mode on Hekate - Please Help

    I’m new to being a DIY electrician and I’m trying to fix the 1-bit mode issue on Hekate for my son's switch. I tried to troubleshoot using a previous thread that mentioned testing the FPC connector with a multimeter. I found that the DAT2 pin is connected to GND. Does this mean the FPC connector...
See more