Papaille's latest activity
-
PPapaille replied to the thread PS5 slim (EDM-040) BLOD (10 seconds to infinite).Thanks for your reply ! i’ve checked others voltages, and find something On the first test point pad on each nand (front and back side) i mesure 0,07v stable. Others tests points are around 1.12v or 0.8v, but nothing so low I’ m not able to...
-
-
PPapaille replied to the thread PS5 slim (EDM-040) BLOD (10 seconds to infinite).i have another question After mesuring voltage rails around ssd area, i found this 2 legs of that component have 3.3 volts present when blod, the other have 0.04 volts. Mesuring in diode mode, All legs show 0.540 v. In résistance mode, the...
-
-
PPapaille replied to the thread PS5 slim (EDM-040) BLOD (10 seconds to infinite).So i’ve replaced the ssd controller. Now All rams and ddr4 memory for the nand pack are warming up with the new controller. Sadly error is still here… blod for around 10 second and shutting down, popping 80801028 uart error. Sometime it stay...
-
PPapaille replied to the thread PS5 slim (EDM-040) BLOD (10 seconds to infinite).That’s m’y next move, replacing the ssd controller. I will post here the issue
-
PPapaille replied to the thread PS5 slim (EDM-040) BLOD (10 seconds to infinite).Thanks for your reply. Do you think it’s normal that not any nand get warm during the infinite blod? Regarding to that, do you think at something else (other than the ssd controller) in order to resolve the problem ? Thanks again
-
PPapaille replied to the thread PS5 slim (EDM-040) BLOD (10 seconds to infinite).To complete, i use a thermal camera to observe what component is warming in blod state After 10 seconds, in ssd aera, only the controller is hot
-
-
PPapaille replied to the thread PS5 slim (EDM-040) BLOD (10 seconds to infinite).Hello, thanks for your reply There is nothing about liquid metal spilling. I will double check again, but i’m pretty sure everything is fine in this way. In addition, ssd controller is on the opposite side of the apu on edm-040 board. Could it...
-
PHello Everyone I brought a defective PS5 slim (rev EDM-040) First failure was the psu (OV output). After replacing IC32, it work again Second failure (and that's why i'm here) is the motherboard stay in a BLOD state. What i've already done : -...
