Recent content by OctupleSauce

  1. OctupleSauce

    Hacking Hardware Homebrew Nandaid help!

    Lmao doing that rn I think I’ll get back on this project later though
  2. OctupleSauce

    Hacking Hardware Homebrew Nandaid help!

    okay checked all the other connections but couldnt save the sd card, the solder was gumming up and not flowing even with a ton of flux. I'm gonna order replacement sd card slots also, do you know what capacitor is used so I can order one of those aswell?
  3. OctupleSauce

    Hacking Hardware Homebrew Nandaid help!

    Checked the connections from the sd card slot and found a giant conjoined mess. All the other connections seem fine on the multimeter. Do you know where I could get another micro sd card slot?
  4. OctupleSauce

    Hacking Hardware Homebrew Nandaid help!

    Ahhh okay good to know. I’m new to multimeters too how do I check for shorts?
  5. OctupleSauce

    Hacking Hardware Homebrew Nandaid help!

    I think I see the problem… I think I broke the resistor that came with the nandaid off… Also think the sd card slot is deformed from heat since the clip for the disk drive is a bit warped but still functioning.
  6. OctupleSauce

    Hacking Hardware Homebrew Nandaid help!

    Ah ok how do I check CLK and CMD? I'm very new to all this.
  7. OctupleSauce

    Hacking Hardware Homebrew Nandaid help!

    got errors from trying to delete scfm and erase mlc. Also the crash logs hopefully they are the right ones. Also idk if this is important but I did use the SD card for rednand temporarily aswell as installing aroma and pretendo on the SD.
  8. OctupleSauce

    Hacking Hardware Homebrew Nandaid help!

    The light on the Wii U stays purple and is not moving off from the screen in the picture. I've left it for a good 10-15 mintues to see if it would change but nothing happens and nothing new is written to the sd card in the front of the wii u either. The SD card has the following: In the...
  9. OctupleSauce

    Hacking Hardware Homebrew Nandaid help!

    Hello. I need help getting the nandaid for my Wii U setup. I’ve checked the connections to all the pads and resistors with a multimeter and triple checked the connections to the sd card slot. When I try the Patch (sd) and boot IOS (slc) option to build the mlc/slc to the nandaid it stays at...
  10. OctupleSauce

    New to GBA Temp

    Hello new to GBA Temp. Ive been into homebrewing my wii and 3ds and wii u but have only had luck following instructions on the internet so far. If anyone can point me in the right direction to understanding homebrew, how its made, where to start etc. Looking forward to not going outside...
See more