Recent content by nimio

  1. N

    Hardware Switch shows Nintendo logo then turns off (no charging icon in left side)

    Finally I change BQ24193 too (M92T36 and BQ24193) but nothing happens, same issue, only "Nintendo" logo and then power off. I'm very lost at this point :sad:
  2. N

    Hardware Switch shows Nintendo logo then turns off (no charging icon in left side)

    Hello, finally I receive the resistors few days ago and solder one 100K resistor in place (very very very... difficult), but nothing happens, same issues: around 4v in pin 5 and 0v in pin 6 (Switch console OFF, with the charger connected to the switch). Maybe now I need to change BQ24193? Regards.
  3. N

    Hacking Black screen after payload injection, usb-c issue?

    It's XAJ70008, due to https://ismyswitchpatched.com/: "Your console is not patched. Hooray!" Maybe if I locate the usb-c test points in the pcb (I don't know where) I can solder some wires with another usb-c only for testing and discard or detect an usb-c issue :unsure:. Some ideas with this...
  4. N

    Hacking Black screen after payload injection, usb-c issue?

    Hello, I buyed a Nintendo Switch with broken usb-c repaired by me, with serial XAJ70008 and 9.1 firmware. I try FAT32 and exFAT sdcard format with some payloads: Hekate, Atmosphere... and nothing, after injecting payload screen becomes black. I don't know what happens, I tested the Switch in...
  5. N

    Hardware Switch shows Nintendo logo then turns off (no charging icon in left side)

    Thanks a lot. Then I order a resistor of 100K with 0201 package. Maybe I try to solder it a Thru hole 100K resistor, for testing meanwhile i receive the smd resistors. Regards.
  6. N

    Hardware Switch shows Nintendo logo then turns off (no charging icon in left side)

    Thanks for your faster answer. I measured again the three resistors in other pcb. From down to up I can measure 10K2, 100K and 100K (last both aligned resistors). Can someone confirm it? Regards.
  7. N

    Hardware Switch shows Nintendo logo then turns off (no charging icon in left side)

    Hello, finally I have good and bad news. Good news: finally the chips arrived. Bad news: When I change M92T36 in some moment I move a component near the chip, the component flipped 90 degrees in the same pads, looks like a resistor, then I try to repaired and the component "jump" and I lose...
  8. N

    Hardware Switch shows Nintendo logo then turns off (no charging icon in left side)

    Hello, sorry for the delay. I'm still waiting for the chips, very slow shipping :( When I receive the chips and try to repair the Switch I will write to all of you. Regards. auto Thanks for the suggestions. I clean and reflowed corrosion areas and checked all ribbon connectors. Anyway I...
  9. N

    Hardware Switch shows Nintendo logo then turns off (no charging icon in left side)

    Ok, then I will change M92T36 when arrive it and measure again pin 5 and pin 6 with same measured results in pin 5 and expecting 3-6v in pin 6 with Switch OFF and charger connected. Thanks for your help.
  10. N

    Hardware Switch shows Nintendo logo then turns off (no charging icon in left side)

    Yes, "Here the results always with charger plugged:" It's ok?
  11. N

    Hardware Switch shows Nintendo logo then turns off (no charging icon in left side)

    It's reflowed with flux around some corrosive areas (maybe I must to reflow again) and I tried other battery that I can see in Hekate that is charged to 100%. And we are here, with the issue. I'm waiting to receive in... around 5 days a few of chips to try to change BQ24193 (or M92T36, or...
  12. N

    Hardware Switch shows Nintendo logo then turns off (no charging icon in left side)

    I restored my (deffective) NAND to begin again to try to repair it. Now I can see again the "Nintendo" logo and then the console turns off and continues no showing the left charge icon during charging (but charge). I don't know if try with other firmware or... what? As I say the console gets...
  13. N

    Hardware Switch shows Nintendo logo then turns off (no charging icon in left side)

    First thanks for your answer. I can't join in recovery mode. Keep in mind that this backup are just the initial problem data (just "nintendo" logo and power off) then don't solve the problem. Regards.
  14. N

    Hardware Switch shows Nintendo logo then turns off (no charging icon in left side)

    Hello, I will to try to explain the problem: I get a 2nd hand Nintendo Switch with water damage. After my inspection I can see few water damage in (and around) usual chips (corrosion in M92T36, BQ24193, PI3USB) and battery connector (and bottom PCB in same area) then I clean the PCB and...
See more
General chit-chat
Help Users
  • No one is chatting at the moment.
    AncientBoi @ AncientBoi: 👍