Recent content by mreverywhere

  1. M

    What is the capacitor value Nintendo Switch oled APU

    I already ordered 10v..is there a problem?or is it working fine...
  2. M

    What is the capacitor value Nintendo Switch oled APU

    hello guys, Does anyone know what is the value for the capacitor?
  3. M

    SP APU pad its give me 34 ohms and 0, its fine?

    hello if on APU pad with resistance mode, it's give me 34 ohms , and other side 0, and other side too the same.. 34, and 0 that's fine? or mean something bad?
  4. M

    After install rp2040 oled I got purple screen

    Hi what is the problem? I installed the chip but the chip was working and turning off sometimes, then I found some components not soldered well and soldered them again, then I got this screen now.. and no color works when I power on now only a screen appears with purple color
  5. M

    Will this cause a short circuit ?

    It stuck to the ground. It stuck to the ground.
  6. M

    Will this cause a short circuit ?

    It's stuck with the soldering wick....
  7. M

    Will this cause a short circuit ?

    thank you so much, Do you have any idea how I can clean it?
  8. M

    Will this cause a short circuit ?

    Good thanks, but in general if this cable is installed now 3v, clk d point, without removing the solder block, is there any problem.. even if the cable touches this solder block?
  9. M

    Will this cause a short circuit ?

    hello Will this cause a short circuit on my switch?
  10. M

    Is this solder bad? And a mess? With d point clk?

    I can't, because it was already stuck to the wick.. and I couldn't remove it.. so I'm asking if I repeat it is okay? By the way, did you see point D at the top.. Should I put a solder mask around the black circle (that I drew)?.. or everything is good
  11. M

    Is this solder bad? And a mess? With d point clk?

    Hi, there is a bridge connecting two ground wires. How clear is it? Near the clk d point... Is this normal and will it not cause me any problems??
  12. M

    why I can't install a game via DBI.

    When I try to install a game using the DBi + usb method.. I tried maybe 8/9 games, none of them work.. Only 2 games were installed successfully... I don't know what the problem is, the 2 games that were installed are very small in size.. I don't think all 9 games have problems..
  13. M

    unknown pks91 version hos version not supported trying backup bootloader

    how to fix that, I just modified the switch now.and i was trying many times to run the switch... but nothing happens only that message
  14. M

    Why does it show 1.4 at point D?

    Yes I fixed it I just put more solder tin.. What do you think of these values now? 3v3 = 0.831v d = 0.755v a = 0.750v c = 0.773v b = 1.383v
  15. M

    Why does it show 1.4 at point D?

    Why when measuring the D point, before installing the chip, does it give me something like 7? But when I install the chip, insert the cables, and test and measure using the chip itself, it gives me something like 1.4 V?
See more