Recent content by MaxMax02

  1. M

    Component search

    Thank you! And for the capacitor, do you have the value
  2. M

    Component search

    Hi ! Do you happen to know the references of what appear to be a resistor and a capacitor located next to the 50-pin connector on an EDM041 board? Thank you in advance
  3. M

    PS5 beeps but doesn't start

    Hi, I’m bringing this up again in case someone might be able to help.
  4. M

    PS5 beeps but doesn't start

    Hey guys, Yesterday, I replaced the Wi-Fi chip — everything went smoothly, and there’s no more short circuit in that area. After that, I reassembled the console: it powered on for a second with a blue light, then turned off. So I decided to take it apart again to check the motherboard...
  5. M

    PS5 beeps but doesn't start

    I received the Wi-Fi chip today, great news, the chip already has its balls. While watching some videos, I saw some people putting solder on the PCB pads. Personally, I was planning to clean the solder with a wick without adding more. What do you think? Just clean, or clean and add solder?
  6. M

    PS5 beeps but doesn't start

    I’m still waiting for the Wi-Fi chip, so I haven’t been able to test yet. I have a question in mind: under the Wi-Fi chip there are several capacitors of the same size. Do you know if they all have the same value? I removed them during the test, but without paying attention to the order...
  7. M

    PS5 beeps but doesn't start

    Indeed, in the photo, it looks like the solder joint is broken. I’ll take a closer look. Regarding the small capacitor near the resistor, do you know its size and value? If I also need to replace the resistor, I’m afraid of losing it.
  8. M

    PS5 beeps but doesn't start

    Thank you for your advice! I’m going to buy a capacitance meter. In my case, both are dead, so it’s difficult to measure them. I’ll replace them with 22 µF ones (according to jkyoho). Does the 0603 size seem appropriate to you?
  9. M

    PS5 beeps but doesn't start

    My multimeter can’t measure µF… Am I taking a risk by doing this? I’ll redo the soldering, but I’m waiting to receive my leaded solder first
  10. M

    PS5 beeps but doesn't start

    Thanks for your reply. For the capacitors, I used low-temperature solder (138 °C), which is much easier to work with. I was wondering if this could cause any issues. As for the two capacitors I replaced, I took them from an EDM030 donor board, choosing ones of the same color and size...
  11. M

    PS5 beeps but doesn't start

    Hello, I picked up a faulty PS5, supposedly never disassembled and still with the warranty sticker intact. Symptoms: the console emits a beep but doesn’t power on no blue or white LED. After disassembly, I found: -No liquid metal -Flux residue around the Wi-Fi chip -UART TX and RX pads torn...
See more