Recent content by livo

  1. L

    Hardware Rcm mode after charging issue

    Hi, sorry been busy, after a bit more testing i have found that when the usb port shorted out as well as m92t36 & p13usb it also broke my righthand joycon, the joy con has no signs of life on any switch i connect it to(we have 3 more switches in the house), could it be the joycon contrioller...
  2. L

    Hardware Rcm mode after charging issue

    Hi, can anyone help me out and tell me why my switch will only boot to rcm every time i turn it on after a charging port, m92t36 & p13usb replacement. The console charges normally now and fast charges both ways round. but i get no screen output or back light. if i connect it to my computer and...
  3. L

    Hardware Another not charging issue

    after doing a bit more checking it connects to my comp via a usb lead
  4. L

    Hardware Another not charging issue

    Hi, the board powering on i can hear it connect and disconnect to my computer when its plugged in and unplugged from the computer, if i hold the power button for around 5 seconds it connects and when i turn it off it disconnects, the back light does not work i have checked the power to the to...
  5. L

    Hardware Another not charging issue

    Hi, i have changed both the m92t36 and the p13usb and have got it to charge and it will fast charge but i still have no image to the screen. any idea where to look next. Thanks
  6. L

    Hardware Another not charging issue

    hi, so i managed to get my hands on another board to find that cap is shorted on that board anyway so i decided to change both m92t36 and p13usb and after that it now draws a current just need to reassemble to make sure it is fixed, thanks for the help
  7. L

    Hardware Another not charging issue

    Hi, one side of both has 3 ohms to ground the other side one has 270k going up and the other has 330k going up i think i may have found the issue i have only one shorted on the cap marked in red on the pic, so i think it may be the Max7762 that is at fault, i removed the cap and it still has...
  8. L

    Hardware Another not charging issue

    Hi, i get 3.8v which is the battery voltage
  9. L

    Hardware Another not charging issue

    Hi, i get the battery voltage on test pad 3 also on test pad 1 i get battery voltage and on test pad 2 no voltage and a ohm reading of 0.3 thanks
  10. L

    Hardware Another not charging issue

    Hi it was drained down to 2.7v i have manually charged the battery to 3.8v it made no difference
  11. L

    Hardware Another not charging issue

    Thanks for the reply with the official charger i get nothing at all, i have tried another official charger same result but with a samsung usb lead and my computer i get 5v both sides of the fuse and all the way up to up to the m92t36 but no it has current draw at all. i seem to have no 3v...
  12. L

    Hardware Another not charging issue

    Hi hoping someone can help me out, i have a switch that my kid destroyed the usb port while running with it while it was plugged in, i have replaced the port twice just for good measure but it still will not charge, after reading and watching loads of videos on youtube i have no shorts in the...
See more