Recent content by laotoulyh

  1. L

    Ps5 migrating APU from edm 030 to edm 010 board.

    Thank you so much!
  2. L

    PS5 UART commands

    Hi everyone, I have an EDM-030 motherboard with the same BLOD codes: two C0020303s followed by 80810001. I measured the standby voltage and found that the TLV62090 on the back of the motherboard had no output voltage. Replacing it didn't solve the problem. I then discovered that pin 13 had no...
  3. L

    PS5 Digital edm-030 2 sec blod (cracked GDDR6 RAM) 80800022

    I repaired an EDM-030 yesterday with error 80801F12. Re-balling the eight DDR6 DDR4 modules didn't solve the problem. Re-balling the APU resolved the issue. I also tested removing one DDR6 module and installing only seven, and the error 80801F12 still occurred.
  4. L

    Ps5 migrating APU from edm 030 to edm 010 board.

    Could you tell me which resistor needs to be adjusted? from 69gg to 61g
  5. L

    Hacking Gaming Project XeCLI: AIO x360 CLI for live debugging, dumps, profiles, Ghidra/IDA, and more

    Thanks for sharing, that's impressive.
  6. L

    How do i get aurora to load up without using a thumbdrive on xbox 360?

    You should use BadUpdate, which has an HDD version and doesn't require a USB drive. However, your HDD must be an official Microsoft product or have its firmware flashed, meaning it can be recognized and used on retail systems.
  7. L

    PicoDurangoPost to diagnose xbox 360?

    The Xbox 360 displays error codes directly on the power switch, so this isn't necessary. For example, codes like 0101 0100 0020 0021 0001, etc.
  8. L

    Misc Others Xbox 360 Hack Pack - Everything You Need In One Download

    Thanks for sharing!
  9. L

    My RGH 3 XBOX 360 freezes randomly when it is on

    Most Xbox 360 crashes are due to problems with the APU 818337, requiring a BGA re-installation.。
  10. L

    Anyone can identify ps5 slim components near ram?

    Great, that's exactly what I need.
  11. L

    Hardware Switch lite FT9CJ resistor value

    If the touch fails, you can look at the two 1K resistors. If it is normal, it may be a problem with the touch chip and you can try to reball.
  12. L

    Hardware Switch lite FT9CJ resistor value

    This should be an inductor or insurance, 0 ohms.
  13. L

    Hacking Hack SXOS

    Yes, this method cannot be applied to SX CORE and SX LITE. Will prompt "boot.dat?" I just tested it.
  14. L

    Hardware Component Back light switch lite

    TPS61163A can replace
  15. L

    Hardware Repair switch, ask for help

    Why is this happening?
See more