Recent content by kingveder

  1. K

    Switch No Boot

    For those experiencing the same it was due to over scraping point A. the resolution was running a jumper wire with .1mm copper further up the trace. I owe the fix to Tvpartsworld and you can view the fix 8 mins in on this video!! (The man is a legend)
  2. K

    Solder Mask breaking my jumper wire connection

    Hey Guys I messed up the point A scrap on my OLED so I repaired the trace with a jumper wire and the switch boots up. After appying solder mask it ruins the repair and the switch wont turn on. Ive went through the process twice now Does anyone have tips for sodler mask or tips on why this is not...
  3. K

    Switch No Boot

    I believe it is the point d on the board that you scrape and solder too. Im thinking I went to far. I put my multimeter in diode 2000 on the multi meter I have and it shows as 1445 which is high compared to the videos Ive watched. Also got my USB tester today and I gentally exposed the trace by...
  4. K

    Switch No Boot

    So I've cleaned up the board and removed any extra solder I could see, also cleaned the ribbon cables but I'm still getting nothing when plugged in, I also went around the points used to solder the mod chip on and took some diode and continuity tests and nothing is standing out. Id be surprised...
  5. K

    Switch No Boot

    Thanks Jack! Really appreciate the vote of confidence. It's given me second wind to get back at it tomorrow. I'll report back as it progresses!!
  6. K

    Switch No Boot

    Hey All, Just tried installing a picofly on my old. It wasn't booting so I started to remove the picofly bit to troubleshoot and noticed I nicked the apu. Is this a complete write off?
See more