Recent content by Jkop

  1. J

    Hacking Hardware Picofly - a HWFLY switch modchip

    Wire is way too big. Just use jumper wire to repair. I just had to repair one this morning
  2. J

    Hacking Hardware Picofly - a HWFLY switch modchip

    Easy fix. A point resistor
  3. J

    Hacking Hardware Picofly - a HWFLY switch modchip

    Trying to pinpoint the problem. I have 2 OLED boards currently trying to repair. One is a emmc problem other is APU which I am pretty sure is dead but before I completely use it as parts I am trying to recover the emmc backup. But I think if you hear it in rcm mode on the pc it most likely is a...
  4. J

    Hacking Hardware Picofly - a HWFLY switch modchip

    Does it detect rcm mode on pc?
  5. J

    Hacking Hardware Picofly - a HWFLY switch modchip

    Yea I am seeing it more and more unfortunately Do you have a emmc reader to see if its dead or try to backup?
  6. J

    Hacking Hardware Picofly - a HWFLY switch modchip

    @rehius First I would like to thank you for all you do. If you have a donate link least I can do is buy you a cup of coffee. Yea I understand how difficult it would be without having the console to test. But 2.80 didnt work
  7. J

    Hacking Hardware Picofly - a HWFLY switch modchip

    Left small chip with lots of fpcs is 2 47 47 221 Right bigger chips is 47 47 47 238
  8. J

    Hacking Hardware Picofly - a HWFLY switch modchip

    2.79 is also a no go. It was working great for a while. It gives a *=* code now. Video below error start around 38 seconds but every other video boot works fine
  9. J

    Hacking Hardware Picofly - a HWFLY switch modchip

    Yes these are the chips I used. Kamikazed dat0. The left I used with samsung emmc and right with SK hynix. I would have to check the ohms but I think the 2.79 firmware from rehius fixed it. Will keep you updated 1725386253 I just updatd to 2.79 from rehius and it works. If I get errors I will...
  10. J

    Hacking Hardware Picofly - a HWFLY switch modchip

    Thank you rehius! Unfortunately it didnt work. I actually have 2 consoles a SK Hynix and a Samsung both with different chips that are doing that. I do change to Instinct V6 and it works fine
  11. J

    Hacking Hardware Picofly - a HWFLY switch modchip

    DId you figure out this problem? I am also having this problem. 1 out of 15 boots into OFW same error code. It's driving me crazy. Redid all points changed out the cpu flex. Mine is also kamikazed. I have retrained, different firmwares spent half the day trying to figure out this problem
  12. J

    Console Color Change - Prodinfo CRC

    So I have done a lot of research on this and cannot get the last step with the CRC-16 values. I checked the code at https://switchbrew.org/wiki/Calibration and don't quite know how to get input the hex values where. I tried to compile and run the code and gives me syntax errors. I have...
  13. J

    Picofly install gone really bad: 3.3V trace capacitors desoldered accidentally

    I would be willing to buy the board. Very easy fix
  14. J

    Is safe replacing of eMMC of Nintendo Switch?

    No you wont be banned. They don't know which brand emmc you started with as long as you transfer over the complete nand you are fine
  15. J

    Hacking Hardware Picofly - a HWFLY switch modchip

    Yup that one
See more