Recent content by irvingoh999

  1. irvingoh999

    Hacking Hardware Picofly - a HWFLY switch modchip

    Hi, for the dat0, clk and cmd points, does the resistor have to be 47ohms on the dot, or can a rough range work? I have some 40-60ohm resistors
  2. irvingoh999

    I screwed up my CLK solder point while installing a modchip on my OLED

    1. Repair the Clk Point, make sure the connection that's close to the CPU (Nvidia Chip) and the Via (This connects through the board, to the EMMC Chip) is connected to each other, otherwise the switch will not boot (Black Screen most of the time) 2. Check the CMD resistor, it's value should be...
  3. irvingoh999

    HWFLY Oled - Black Screen and chip shows no light whatsoever

    Check for a bridge on the 3.3v power rail. If its bridged, try repairing it like a faulty switch, check the m92t36, p13usb and bq chips (capacitors around those chips) for shorts.
  4. irvingoh999

    Switch can boot into CFW, but not into OFW/cfw(sys).

    Boot into hekate and check the emmc info, see if there's any data. If it's on slow mode or there's no data you might have a broken/bad emmc
  5. irvingoh999

    Switch can boot into CFW, but not into OFW/cfw(sys).

    Are you using a unpatched erista or mariko switch?
  6. irvingoh999

    Switch OLED (HWFLY) not starting properly

    Take apart the switch and test the C point (best to test all the points) in diode mode. See if the reading flactuates. If you are getting a reading that flactuates or is grounded or anything that seems sketchy, checking the wiring for that point. Most likely your dat0 adapter has come loose...
  7. irvingoh999

    Switch OLED teardown V1/V2

    Hi, so I was installing an oled v3 chip (locked chip) and then this happened, the cpu shield touched the clk point. Now I can't boot ofw at all, black screen. Any suggestions? Thanks!
  8. irvingoh999

    Glitching Headphone/Sound IC issues

    Hi all, I've been having Issues with my modded OLED switch. Everything works fine except for the sound. It switches between headphone connection to speaker and vice versa once the switch turns on. This keeps happening either on OFW or CFW. I removed the headphone jack/game card/sd card combo...
  9. irvingoh999

    Hardware What is the capacitor value on top of Nintendo Switch APU?

    Hi, would like to ask specifically what was the configuration you had that still allowed the switch to work? I was soldering an sx core chip and knocked out one of the caps on the cpu, and have been trying to solder it back since, but to no avail. Do I just leave the cap off the cpu? Or do I...
  10. irvingoh999

    Nintendo switch OLED alt point for modchip install

    What value does the resistor have to be? Any good number?
  11. irvingoh999

    Nintendo switch OLED alt point for modchip install

    I have a spare original sx core that I never got around to installing. Was wondering if it would work on an OLED switch. I know there have been a few issues and it would be best to just get the latest oled chips and it would probably be easier to solder but I would like to know if its possible...
  12. irvingoh999

    Nintendo switch OLED alt point for modchip install

    Is it better to have the sx lite? I already own an sx core, keeping it for this purpose, but I read online on the comments in the original YouTube video that it is a hit and miss, that dat0 needs to be removed in order to run OFW? Will installing a switch be a solution? Or is the sx lite a...