Recent content by HunterCustom

  1. H

    OLED is about a 50/50 of booting into Hekate

    Hey all I am attempting to mod an OLED but it’s about a 50/50 shot if it glitches correctly or not. When it’s not successfully glitching I get red red red, purple, solid white. From what I found online it’s an issue with the capacitors so I resoldered made a solid connection but still get this...
  2. H

    OLED getting D0 error but I have correct diode voltage

    oh it was improved this photo was purely because I was diagnosing the issue
  3. H

    OLED getting D0 error but I have correct diode voltage

    Hi there, console works fine with the new instinct NX chip I got
  4. H

    OLED getting D0 error but I have correct diode voltage

    I’ve had luck with these on the v1/2 and LITEs but never the oled and I’ve always used the firmware from your provided link. I’ll definitely check out the video you included though see if that would help. But I did end up ordering an instinct off Ali Express last night might as well throw a...
  5. H

    OLED getting D0 error but I have correct diode voltage

    Hey guys sorry, Naming threw me off. I have an instinct v6 clone version such as this image 1712713047 this is my DAT0 connector, and I still get the long short error 1712713328 Here is a clip of the error code (incase Im reading it wrong as i've done before) 1712716154 update before i go...
  6. H

    OLED getting D0 error but I have correct diode voltage

    I don’t have any that im aware of im just using what was included I have one of those PCB ones but I’ll look into grabbing the 47ohm resistor see if that helps
  7. H

    OLED getting D0 error but I have correct diode voltage

    Hi all, I’m trying to install a new picofly RP2040 into my oled switch as the one that was originally installed by someone else ended up failing however when booting the switch I get blue Long green short green indicating a DAT0 error however my DAT0 solder adapter reads in the range of...
See more