Recent content by Haythad

  1. H

    Dreamcast problems after power surge

    Been facing a similar situation on my end, I bought 6 of Dreamcast consoles (mix of VA0 and VA1) all boards show 2v on the 3.3v rail (at the input pin, tp117, and at pin1 of ic104) , even after cleaning the pins or using tp117 as an injection point, the voltage at pin1 of the ic104 is 2v. After...
  2. H

    Hacking Hardware Yet another failed DIY attempt and a request for help

    don't know if this is what you had in mind. 1777080193 Thanks for the detailed response. Regarding the SP1/SP2 continuity. good to know that the insides and outsides being connected on the original Switch might explain what I'm seeing. I'll check if the same applies to my HAC-001(-01). On the...
  3. H

    Hacking Hardware Yet another failed DIY attempt and a request for help

    Hey everyone, I come to you in my darkest and most shameful hour, hoping to get some help with a Picofly rp3040 lite chip install gone extremely wrong on my HAC-001 Mariko V2. During the install I accidentally lifted the SP1 pad while desoldering the flex cable because it wasn’t soldered...
See more