Recent content by grimacelord

  1. G

    CFI-1215A | EDM-030 | Stuck In Safe Mode 99% Processing

    Hello, I have a CFI-1215A PS5 (EDM-030 board) here that won't boot normally. It currently will immediately boot into Safe Mode upon power button press with a screen that says "Processing" and then a progress bar that usually begins around 75-84% and slowly climbs up to 99% where it will hang...
  2. G

    PS5 - EDM-010 - Component Identification & No Power Issue

    Just wanted to come back with an update. Since I had 5VSTBY on every other test point except for the one located next to F7502, I decided to run a jumper wire from F7502 to the test point that is supposed to have 5VSTBY. This then turned on SBV TI stepdown chip and solved my problem. PS5 works...
  3. G

    Xbox One S - 12V Rail Short - Q9F1 Keeps Blowing

    Hello, Have an Xbox One S here that has a short on the 12V power rail. There is no power, beep, or partial fan spin when connecting power cable. After diagnosing with thermal camera, Q9F1 MOSFET (NTTFS4C50N) is getting hot. When I remove this MOSFET, the short on the 12V rail disappears. I...
  4. G

    PS5 - EDM-010 - Component Identification & No Power Issue

    Thank you for the help in identifying the component! I did check the resistance to ground at the "missing" pad that is supposed to have 5VSTBY and I am reading 4.2 megaohms. Diode mode reading of the same pad is 0.486V. I do have 5VSTBY present at other test points on the board. It appears...
  5. G

    PS5 - EDM-010 - Component Identification & No Power Issue

    Thank you for your reply, but I already knew that I should have 5VSTBY at that pad and don't. It reads 300mV whereas it should be 5V. The fuse is no longer blown after I've replaced it and removed the shorted cap and 12V is applied at main socket. I am suspecting that the component I have...
  6. G

    PS5 - EDM-010 - Component Identification & No Power Issue

    Hello, Working on a PS5 that came to me for no power. Console would not beep or power on when pressing the power button initially. Board model is EDM-010. I began by taking the console apart and performing a visual inspection on the board. Everything looked fine. I then tested the various...
  7. G

    CUH-2115B - All Controllers Won't Sync - Even In Safe Mode

    Hello. I'm hoping someone here can help me. I have a PS4 Slim model CUH-2115B, board number SAE-004, that has a problem with syncing controllers. No matter how many controllers I try to use with this PS4, none of them will sync to the console, not even in Safe Mode. I have tried multiple...
See more