Recent content by eMikey

  1. E

    Hacking Black screen after ChoiDujourNX FW 12.0.0 update (original switch)

    OK. My guess is that I just need to blow everything away and start fresh, or should I convert? I will look for a tutorial.
  2. E

    Hacking Black screen after ChoiDujourNX FW 12.0.0 update (original switch)

    I have a original (non chipped) switch running sxos 3.0.5 emunand. I attempted to upgrade the FW with ChoiDujourNX from v 10.2.0 to 12.0.0. The install seemed to go fine, I used exfat. At the end I had the he hekate_ipl GC warning. Upon reboot I get back to the sxos menu, when I select "boot...
  3. E

    Hacking Question Will there be a CFW other than SXOS that allows usb 2tb HDD?

    Just to add to my last post, the HDD spins the same way even when the switch is removed from the dock. I assume this means its not an issue with SXOS but with the way the Switch dock handles power to the USB ports.
  4. E

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    That site is a little overwhelming. There are a lot of options to filter thru. Is this a .5 or .3 pitch? EDIT: Apparently these are not available. Found a dude in China that has a few off of other switch mainboards.
  5. E

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    i ordered an air gun and microscope earlier this week. Thanks.
  6. E

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    So after getting everything installed I go to start and nothing comes up on the screen. My dumb ass bent the screen ribbon cable clamp pins. Any one know of a thread or post that addresses this kind of shitty mistake? If not does any one have any suggestions?
  7. E

    Tutorial Internal modchip - SAMD21 (Trinket M0, Gemma M0, ItsyBitsy M0 Express) Guide, Files & Support

    Please let me know if I have this correct. I'm using a Trinket M0. My goal is to always boot in to CFW (SXOS) unless I hold the reset button down on the Trinket M0 to boot in to OFW. "Version 2" Step 1. Download Trinket_Rebug_Bootloader_Pack.zip Extract and flash the trinket with...
  8. E

    Hacking Question How many of you use AutoRCM to safe fuses?

    Those that use trinket.. The videos I've seen shows that if you boot normally, you boot in to OFW.. If you power up with the vol+ key, you boot in to SXOS. If this is the case, how do you get to the sxos settings page? Like where you enable emunand and external payload launcher?
  9. E

    Hacking Question Will there be a CFW other than SXOS that allows usb 2tb HDD?

    The crappy part about HDD support with SXOS is that in sleep mode, the HDD is constantly active, it never sleeps. It just spins and spins and spins...... It sucks that I need to unplug it after every session.
  10. E

    Tutorial Remove Update nag on 6.1.0

    Is it even possible to remove the nag for games to update? Every game I launch says there is an update?
  11. E

    Hacking Do I have a complete NAND backup?

    I used SXOS 2.3 to create a NAND Backup before running Emunand. There were several options to choose from. I selected all except the 2 that mentions backing up the partition(s). The backup looks like Boot0.bin, Boot1.bin, full.00.bin,.......full.07.bin. The size of all of these are 29.1GB...
  12. E

    Homebrew Question Restoring old version from RAWNand backup?

    Starting with FW 4.1.0 I followed the "switch-hacking-101-how-to-launch-the-homebrew" tutorial, backing up my nand per instructions: After everything was complete I was messing around and ended up super nagging my switch, needing to upgrade to 5.0.2. Is there anyway to go back to 4.1.0 using...
See more