Recent content by Eierfeile

  1. E

    Picofly AIO Thread

    i took them from github..3 hours ago. let me check first post 1681910595 yeah seems like that my chip is cursed... the color after the flash-reboot is purple and not red... i think its time for me to pull the plug here. first it kills my battery registers (still not solved) now it wont update.
  2. E

    Picofly AIO Thread

    yes, yes and no actually not. maybe i was too fast searching through pages 1681909055 2.2uF 10v size:0402
  3. E

    Picofly AIO Thread

    your errorcode is most likely a blown m92. but looking at the cap soldering you should replace the cap and the m92. then it should boot without errorcode to stock fw. question from my side: i tried to update the chip from 2.64 to 2.65 using the toolbox. placed the toolbox in...
  4. E

    Picofly AIO Thread

    yes i am able to charge the console but that is not the problem. the problem is that neither OFW nor CFW is booting. i am stuck with a hekate tablet...
  5. E

    Picofly AIO Thread

    Anyone experienced that after the installation of the picofly the complete battery info is gone? i already replaced the fuel gauge but the problem is still there
  6. E

    Picofly AIO Thread

    the CLK point on the Switch Lite goes through 2 layers on the PCB. you can place 0.25 or 0.3mm solderballs on the ripped pads and reflow with hot air. (small nozzle,relatively high temp and lowest airflow) and then hope for the best that the balls stick to the vias. if yes then you can make a...
  7. E

    Picofly AIO Thread

    so i managed to reactivate a V1 to test the emmc and turns out the keys are fu**ed up. Keyblob 0-5 and CAL0 error on SSL and ETICKET and somewhat with biskey 0. anyone have a idea about that?
  8. E

    Picofly AIO Thread

    it is indeed a ipatched v1.. HAC-CPU-20 i will try with 2x 47R and if thats not gonna work i will reball the emmc and hope for the best. and i havent done diode readings yesterday because it was almost 1am and i was a bit pi**ed off ;)
  9. E

    Picofly AIO Thread

    the soldering was good. all masked up with conformal coating and it worked. but after the strange behaviour of the emmc i decided to desolder the chip and go back to stock. but i think i will resolder it to hopefully recover some stuff off of it.
  10. E

    Picofly AIO Thread

    can you explain the "pikabrick" in short words? asking this because i maybe am in the same situation after removing the chip from the console and now its dead. and of course i didnt make a nand backup because the installation was making trouble. no batt %, emmc issues (slow mode) and last thing...
  11. E

    need help with resistor and capacitor values

    Hello everyone, i need help identifying values of 3 resistors and the 2 caps left from the APU because i have a board where the resistors are knocked off and one of the caps is in bad shape (ripped corner) and there is a short around the MAX77621 left from the APU, desoldering the MAX doesnt...
  12. E

    SD-Card Reader getting no voltage

    Hello, just registered here because i have a problem with a V1 Switch SD-Card Reader and need some advice. When i got the Switch i knew it had problems with the SD-Card reader and changing the SD board didn't solve the problems. Thats when i start measuring in diode mode.. started at the...
See more