Recent content by banemitic

  1. B

    Very RARE Switch Lite MicroSD 1bit speed problem

    OMG, this was very clumsy. Solder drop was hidden behind part of the chip flex used to screw it down. Not event soldered to MicroSD points, just pressed down by screws from heatsink and speaker. Shorting pads for 1 and 2 pins, resulting enough other pins for 1bit mode and working slot in...
  2. B

    Very RARE Switch Lite MicroSD 1bit speed problem

    This is for V1 and V2. Light is different. Has slot soldered on the board and not sure what components - not clear to me to follow traces.
  3. B

    Micro sd card reader - Switch Lite

    Hello. I don't want to make duplicate threads, I have similiar, yet different problem. Any suggestions. Thanks. https://gbatemp.net/threads/very-rare-switch-lite-microsd-1bit-speed-problem.649651/
  4. B

    Very RARE Switch Lite MicroSD 1bit speed problem

    Hello. Sorry about longer message, please read if you can... at least last part. I just installed RP2040 (the one with prepared to solder on points, without wires) on my Switch Lite. Everything seems to be alright regarding that. But when I first entered Hekate I received message "Your SD Card...
  5. B

    Soldering after broken SP2 for CPU flex - is this going to work?

    I understand. But the problem is I have ground for SP2, but no way to connect to SP2 to + where it should be. My question is should I leave like that or try to connect to + to some other capacitor. + of the SP1 and SP2 are connected on CPU flex, too. But I am trying to understand why you need...
  6. B

    Soldering after broken SP2 for CPU flex - is this going to work?

    Can you please explain this to me? Thank you.
  7. B

    Soldering after broken SP2 for CPU flex - is this going to work?

    Thank you. Can I get some guide and values to check soldering with multimeter. I was only able to find values where pople have some problems.
  8. B

    Soldering after broken SP2 for CPU flex - is this going to work?

    The problem is I send this to a friend, just the board, to repair what is possible after SP2 capacitor was knocked off. So he cannot try is this working. The problem is the left pad of the place of SP2 capacitor was damaged and he says he is not able to solder capacitor or flex down there. Right...
See more