Recent content by andy_mg2000

  1. A

    Magnet wire sizing for install

    Yeah. The ruler was more to give an idea of scale I’m talking about rather than an accurate measurement. So I think hair like wire is to be expected, but was just a little hesitant as it’s much thinner than anything else I’ve used before.
  2. A

    Magnet wire sizing for install

    I have been around soldering for some time and usually use kynar 30 awg for most tasks. Having read on the Trinket M0 thread that 40 awg magnet wire was recommended I thought I would order some, and so I got 0.08mm which should be slightly thicker than 40 awg. However looking at what's arrived...
  3. A

    Hacking Question How far off are we from permanent CFW

    I don’t get the fuss about coldboot to CFW. I bought a trinket m0 and a coin cell board (holds a standard cr2032 battery), soldered them together (its simple and guides are on here) then wrapped it in electrical tape to protect the board. I modded the joycon with a magnetic reed switch (again...
See more
General chit-chat
Help Users
    BakerMan @ BakerMan: well then show them how to scratch it (this is a verbalase joke)