[HELP] Instinct Chip Oled Flashed Purple, Yellow and Red

[AMRamos97]

Hello,

I've got an oled with Instinct installed that used to work nice.
I turn the switch on and the chip light flashes purple, then yellow, then purple again and finally either red, then loads stock mode.
If i turn off my switch after 10 secons it flashes again purple and red. I took my console back to the person who installed the chip and he told me that everything was fine, that it could be a bug in the chip.
What could be the problem?
Thanks.

 

[eljay99]

Hello,

I've got an oled with Instinct installed that used to work nice.
I turn the switch on and the chip light flashes purple, then yellow, then purple again and finally either red, then loads stock mode.
If i turn off my switch after 10 secons it flashes again purple and red. I took my console back to the person who installed the chip and he told me that everything was fine, that it could be a bug in the chip.
What could be the problem?
Thanks.

did you solve this? i'm having same issue and it was working fine for a day after i installed the mod chip

 

[Phantomas77]

did you solve this? i'm having same issue and it was working fine for a day after i installed the mod chip

See if this helps to pinpoint the problem.

 

[eljay99]

See if this helps to pinpoint the problem.

unfortunately my problem isnt listed here. Mine is: blinks purple for a long time + flash yellow about 10 times + blink purple for some time again + blink red 4 times + turn off + switch starts up into OFW

 

[Phantomas77]

unfortunately my problem isnt listed here. Mine is: blinks purple for a long time + flash yellow about 10 times + blink purple for some time again + blink red 4 times + turn off + switch starts up into OFW

Are you sure it's yellow? Sometimes white on RGB could look a bit like that. Did you use DAT0 adaptor or reball the eMMC?

 

[switch-it-up]

Are you sure it's yellow? Sometimes white on RGB could look a bit like that. Did you use DAT0 adaptor or reball the eMMC?

You can see pretty clearly in the video that it's a yellow or orange hue, definitely not white.

Even if it were white, the combination still doesn't correspond to any of the error codes on the Instinct V6 table.

 

[jkyoho]

 

[Jamisons]

Hi there, did you have any luck with this? My switch appears to be doing the same as yours

 

[canadabro]

I am having this issue when I start to reassemble my Switch after installing a Instinct chip. OLED ofc.

If I take all the screws back out, no problems it glitches.

What might be doing it?

 

[bvang913]

Might be shorting out on something? You got kapton tape over the chip or anything that might have contact with the metal shield?