Post your log (set loglevel to 3)Hello, thanks for your app
But when i try to stream , sometimes it goes on 37 fps and is greatly streaming but it doesn't last long and then it goes on 3-10 fps
Any ideas ?
Post your log (set loglevel to 3)Hello, thanks for your app
But when i try to stream , sometimes it goes on 37 fps and is greatly streaming but it doesn't last long and then it goes on 3-10 fps
Any ideas ?
That's a confirmed NTR CFW bug. I suggest you use homebrew emulators instead.Try out the new version understress, with something downloading in the background ecc, and it works fine (considering that my internet is made crap).
Only thing i notice is when i enter a VC game from GBC (in my case specificly is Pkmn Gold) the color get strange. Like im playing a GB game on a GBC and the system give to them pre maded pattern of color.
I noticed this even with kit kat stream.
Nope. Not only this relies on NTR's remoteplay, but N3DSes already struggle with screen streaming,so streaming audio via Wi-Fi would mean very poor performance with both. If you want to stream audio I suggest you buy a 3,5mm male-to-male connector: plug one end to the headphone jack of your 3DS and the other to your PC's mic in port. These cables are very cheap (you can find them for less than 2 Eur on Amazon or eBay) and if you have some broken headphones lying around, you could also DIY one yourself, even without a soldering iron!will this play sounds during streams or no?
That's a confirmed NTR CFW bug. I suggest you use homebrew emulators instead.
Nope. Not only this relies on NTR's remoteplay, but N3DSes already struggle with screen streaming,so streaming audio via Wi-Fi would mean very poor performance with both. If you want to stream audio I suggest you buy a 3,5mm male-to-male connector: plug one end to the headphone jack of your 3DS and the other to your PC's mic in port. These cables are very cheap (you can find them for less than 2 Eur on Amazon or eBay) and if you have some broken headphones lying around, you could also DIY one yourself, even without a soldering iron!
Here it isPost your log (set loglevel to 3)
Your log looks fine but it seems that your connection gets dropped a few times here and there. Are you sure it's not a connection issue? (Remember that screen streaming uses lots of bandwidth and that if you're far away from your router then you'll get poor performance)Here it is
Hmm , i don't think i have problem with my internet and i'm close to te router...Your log looks fine but it seems that your connection gets dropped a few times here and there. Are you sure it's not a connection issue? (Remember that screen streaming uses lots of bandwidth and that if you're far away from your router then you'll get poor performance)
I don't think this will work either but you can try to see if it's work ^^What about running the game via TWLoader?
Which game are you trying to stream?Hey there! Would this operate with 11.6 at the moment? I'm having issues with NTR, Kitkat and Snicker where it connects but then drops FPS or freezes completely and have yet to find a solution, any ideas?
Update: DS disconnects from the internet. Running an upload speed of 25mb/s and DL of 75mb/s
It connects for a bit, stays at 35-40 FPS, drops, loads the screen of the game but then doesn't load the actual game. Maybe I'm doing something wrong?
They can be in two different networks but I do not recommend it (you'll have to port forward, which could cause some problems - read the FAQ).Quick question... Does the 3ds have to be connected to the same connection as the PC? I have my 3ds connected to one router and I have my PC connected by ethernet to a different router. (It doesn't have a WiFi thingy in it)
The logfile stops right after it tries to init remoteplay (hotkeys don't work because they will be available for use right after the stream starts). You might want to try to adjust WaitRemoteplayInit to a different value (lower=snickerstream will wait less before initing remoteplay, higher=the opposite).Hey! I have a problem with starting Snickerstream (Kit-kat works fine).
I'm starting NTR-CFW 3.6 and then I use Snickerstream defaultoptions to try streaming.
IP's are correctly set and when i press Connect-Button, the topscreen of 3DS is flickering.
But after that Snickerstream window is just black, no FPS counter, nothing.
I also tried restarting everything a few times.
Logfile seems not mentioning any errors.
One thing i want to mention too, none of the hotkeys are working in my case.
Thanks in advance guys!
I have got a single monitor setup here so I haven't tried it, but it should work as any other regular window. If you maximize it, it should become maximized in the currently active monitor.can i choose to which monitor the software will stream? if yes how?