Hello guys, this is my first post here! I just got a MIG Switch card out of curiosity and I was tinkering with it. For those who don't know, it's used by placing XCI dumps as well as other game specific bin files in the sd card of the MIG Switch, and are obtained from the original cartridge by using an app like nxdumptool. Two of these bin files are mandatory to get the game to boot: Initial Data.bin and Certificate.bin. They stay the same for every cartridge of a specific game. Now, if you want to use an XCI dump from a shady website it's impossible to get it to work without those files. By using the Certificate.bin from another game it has no problem, but this does not count for the Initial Data.bin. So I looked for a way to obtain this Initial Data from an XCI file and read a bit of the XCI file documentation from switchbrew dot org. Here's what I understood so far: The Switch checks if the cartridge is valid by doing a challenge–response authentication on the Initial Data. The Package ID is contained both on the XCI and the Initial Data, on positions 0x110 and 0x0 respectively. The Initial Data hash is on the XCI at position 0x160. It is calculated by doing a SHA-256 hash on the full Initial Data content. So I was wondering, is there a way to to construct a functional Initial Data file starting from an XCI dump? I also tried a reverse approach by editing the Package ID in the Initial Data from another game, generating the Initial Data hash and putting it in the XCI file but is not enough to get the Switch believe it's a real game. Sorry if this may seem stupid but let me know what you think.

mig switch not working/updating??

stickybit · 2024-03-28T19:59:51+00:00

just got my mig switch and followed instructions to the T to update it and all im getting is a red light and then a message saying cart not recognised, all im trying to do is update it to the latest firmware, it says it should flash blue when...

right joycon problem

Thread starter LuigiGad
Start date Mar 21, 2024
Views 451
Replies 3

LuigiGad

Well-Known Member

Member

Level 4

Mar 21, 2024

Hello, I have a right joycon that when docked to the console is recognized by the insertion with relative animation on the screen but then it is not recognized by the Switch and does not load. wireless is recognized. The Switch is operational because it works with other joycons. Joycon rail shifted but nothing. Tips?

Hayato213

Newcomer

Member

Level 28

Mar 21, 2024

Then the problem is that specific joycon. Open it up and inspect it.

worm28

Well-Known Member

Member

Level 7

Mar 21, 2024

Inspect the pins on your joycon one of them could be bent if not you may need to open it up and have a look it sucks that joycons are so expensive and they come drift prone.

LuigiGad

Well-Known Member

Member

Level 4

Mar 21, 2024

having availability of fully functional joycons and having carried out cross tests I can state that console rail ok, joycon rail + st/sl strip both new ok.
Edit:
solved with scotch tape to enlarge the flat. the problem was the connector on the board