yesso theres no difference between using the pinouts on the emmumc or using the ones on the board? just a matter of prefference.
Do you see the firmware version installed on the rp2040 from the pikofly toolbox on your switch modded with rp2040?there are shematics on the first page only us connections on emmc connector if u know what u are doing otherwisen use different pinouts
Post automatically merged:
did u reboot?
Shot a photo, only this we can help you.I did everything but when I try booting it the led:
Blue/pink then nothing and then stay on blue, there isn't any sign of life from the switch so what did i do wrong?
Btw the 3.3v resistor got off and i put it back so that's maybe an issue?
yeah i saw itDo you see the firmware version installed on the rp2040 from the pikofly toolbox on your switch modded è with rp2040?
Post automatically merged:
Shot a photo, only this we can help you.
That sounds like a false statement.There's a rumor going around that the author of PicoFly just got served papers. Does anyone know if there's any truth to that?
Whos the supposed author?That sounds like a false statement.
I couldn't really get any clear pic
View attachment 364184
View attachment 364185
View attachment 364186
This time it got blue for 3 seconds, then cyan for 0.5 seconds.
Then usually stays on blue
Before it was pink in place of cyan.
Do that means that i have a bad cpu / clock ?
Btw I used a mosfet and the wires are under the thermal paste and tape
I connected everything on the emmc board and connected 3v and gnd to the resistors on the second picture
I don't have an idea why it's written 5•3 on the switch..
to big wont fit unless you cut it downI'm sorry to ask but can this be done with a regular rpi pico ? I can't figure out the rgb mode the standard unit boots with a green light and then goes out so I try to bridge gp pins 25 and ground but I'm not getting an led color change nit matter what I try
Aw I was hoping removing the button and port was enough oh well. Thanksto big wont fit unless you cut it down
if u get cyan that means u need to check ur cpu pi u might have to install a second mosfetI couldn't really get any clear pic
View attachment 364184
View attachment 364185
View attachment 364186
This time it got blue for 3 seconds, then cyan for 0.5 seconds.
Then usually stays on blue
Before it was pink in place of cyan.
Do that means that i have a bad cpu / clock ?
Btw I used a mosfet and the wires are under the thermal paste and tape
I connected everything on the emmc board and connected 3v and gnd to the resistors on the second picture
I don't have an idea why it's written 5•3 on the switch..
Update to 2.62Hi all!I have my Lite RP2040 zero FW2.61 mod.Everything is running smooth but have an issue that trying to boot OFW by Power Vol+ and Vol-,give me the black screen and need to power off by holding for seconds.But in Hekate,can boot into OFW.Is this a common issue for Lite?
Updated to 2.64 but still can't boot into OFW by holding vol+ and vol- 1st then short press power button once?Am I doing the right sequence?Update to 2.62