NTRBoot Released!

It's here!
ntrboot_checklist_2.png

Info

@Normmatt has created a way to run B9S .firm files from bootrom via a DSi Flashcard and a magnet! This works on every 3DS on any firmware version.

For installation without a PC, user @TheCyberQuake has created a pack which will automatically install B9S and copy over essential starter homebrew from the flashcard's SD to the 3DS's. This will mainly be used for PC-less B9S installations. If you have a PC with you, use 3ds.guide. Read more here: https://gbatemp.net/threads/481141/

How does this work?

This works because of a flaw in the bootrom. Before the bootrom boots the NAND, it checks to see if Start+Select+X is held down, and if the shell is closed. If these requirements are met, it will boot an NDS cartridge from the bootrom. This give that cartridge bootrom access. You might be wondering how you'd hold down buttons while the shell is closed, and why you need a magnet. If you put a magnet in a specific spot on the 3DS, it will go into sleep mode. Using this, you can boot the NDS cartridge with the buttons held down while in sleep mode! Using a reflashable flashcard, you can boot B9SInstaller using the flashcard, and easily install it on your 3DS.
The 2DS doesn't need a magnet since a switch puts it to sleep instead of a magnet.

What does this mean?

  1. Any 3DS model on any firmware can be hacked with minimal effort
  2. You can unbrick any 3DS model from any type of brick.
    - Remember, you don't need a NAND backup for this. Just do a CTRTransfer.
    - This does not apply to MCU bricks.
  3. Even consoles with fried NAND, or even the NAND chip physically removed, can use this
This is incredibly impressive stuff, and will most likely be released soon! edit: now!

FAQ

Q: Can Nintendo patch this?
A: Nope! Not without a new hardware revision.

Q: My flashcard is blocked by my firmware! Can I still use this?
A: Yes! The flashcard blacklist is not enabled on the bootrom.

Q: Why can't this work with my flashcard?
A: The installation requires you to flash NTRBoot to the flashcard's nand. Most DS flashcards, such as the original R4, have a ROM, which is not flashable.

Q: Can I install NTRBoot on my flashcard without another 3DS system?
A: If you can run NDS roms on your 3DS with it, then yes. If it's blocked on your 3DS version, then you'll need another 3DS system to use it.

Q: Will my 3DS flashcard work?
A: No, only the NDSi flashcards listed above.

Q: Will any other flash cards work?
A: Only the ones listed in the OP. However keep in mind that flashcards such as the DSTT, Supercard DS2 and R4 SDHC Dualcore are planned to be supported in the future.

Q: I tried to do this with my cartridge and it didn't work?
A: It doesn't work with regular DS cards.

Q: Can I unbrick from a ____ brick?
A: Considering the card has access to the bootrom, yes! This can unbrick any brick (except MCU), unless you've taken a knife to the motherboard.

Q: Can I install B9S on the latest firmware with this?
A: Again, since the card has access to the bootrom, you can do this easily! Just plug in your flashcard, boot up using the magnet and button combination, and install.

Q: Does this work on the New Nintendo 2DS XL?
A: Yes!

:arrow: Release
:arrow: Guide
:arrow: Free NTRBoot Flashing
:arrow: Free B9S Installations

Here is SciresM's post about this

Please see SciresM's presentation on bootromhax.
 
Last edited by Deleted member 381889,

GBHAKC75

Well-Known Member
Member
Joined
Jan 26, 2008
Messages
406
Trophies
0
XP
563
Country
France
When flashing the flashcart with ntrboot flasher, use this boot9strap_ntr https://github.com/Aluminite/boot9strap/releases instead of the official one. This is specifically made for that purpose.

Sent from my SM-G950F using Tapatalk

Exactly what I was looking for, thanks a lot !

In short, yes (and has been done and linked to at least a couple of times in this thread already), but that's a no good excuse anyway. You can replace your boot.firm with safeboot9installer, and test it. If it didn't work, then NOTHING will display while the magnet is in the correct spot. If it works, then it will boot as soon as you let go of the buttons (with magnet still there, even)

Even without testing purposes in mind, I'd rather have NtrBoot loading GodMode9 or B9SInstaller so I could keep it as "ntrboot.firm" and CFW/loader as "boot.firm" when installation is done, so I don't have to swap files after install.
 
  • Like
Reactions: DocKlokMan

Ritsuki

ORAORAORAORA
Member
Joined
Mar 15, 2008
Messages
1,618
Trophies
1
Age
34
XP
2,577
Country
Switzerland
Little question, I remembered seeing that compatibility with SCDS2 was un progress. The info is now gone. Is there a reason for that? Also I remember it was attached with a picture of SCDS2+. If the SCDS2 compatibility is still a thing, will it be for SCDS2 or SCDS2+?
 

GravitySuitCollector

Well-Known Member
Newcomer
Joined
Feb 7, 2017
Messages
76
Trophies
0
Location
OR
XP
71
Country
United States
So if it does work it should be added on the compatibility list.
I believe what d3m3vilurr was saying is that the nds version of the flasher was updated to also support the r4i gold (it only did ak2i before, this means you only need a regular DS now instead of a CFW'd 3ds for both ak2i and r4i Gold). He wasn't saying it was updated to support more cards than what have already been released/are known for the current ntrboot_flasher.
 
  • Like
Reactions: Pablitox

Snooli

Well-Known Member
Member
Joined
May 25, 2017
Messages
188
Trophies
0
Age
25
XP
151
Country
There are a r4 sdhc dual core build?
I am too lazy to build it, as I don't have a flashcart to use of my own. But there are files for it on GitHub, so Kitling likely has one.

--------------------- MERGED ---------------------------

Yeah I do (good ol' Ds lite), did I miss something from the post that uses it?
Perhaps, I posted about this a few pages back. Here's the GitHub:
https://github.com/d3m3vilurr/ak2i_ntrcardhax_flasher
BTW for as long as you don't restart the DS, it holds the backup in RAM.

--------------------- MERGED ---------------------------

Just like there is no DSTWO build, only plans. I would say come back in a few months.
Kitling has added experimental support:
https://github.com/kitling/flashcart_core
But there are no built .firms floating around
 
  • Like
Reactions: Quantumcat

Agent Moose

Well-Known Member
Member
Joined
Dec 6, 2014
Messages
407
Trophies
0
Age
33
XP
552
Country
United States
Does anyone know what the name of the company is when you buy from nds-card? My bank put a hold on a transaction from china because well, obvious reasons, I'm not in china.

I did try and buy a card from nds-card but I also declined the purchase to my bank because I didn't trust the name of the company that they said it was. It was something like "VIP" or something. Also, the price was a tad more than what I expected too. Maybe taxes?
 

Quantumcat

Dead and alive
Member
Joined
Nov 23, 2014
Messages
15,144
Trophies
0
Location
Canberra, Australia
Website
boot9strap.com
XP
11,094
Country
Australia
I am too lazy to build it, as I don't have a flashcart to use of my own. But there are files for it on GitHub, so Kitling likely has one.

--------------------- MERGED ---------------------------


Perhaps, I posted about this a few pages back. Here's the GitHub:
https://github.com/d3m3vilurr/ak2i_ntrcardhax_flasher
BTW for as long as you don't restart the DS, it holds the backup in RAM.

--------------------- MERGED ---------------------------


Kitling has added experimental support:
https://github.com/kitling/flashcart_core
But there are no built .firms floating around
Does the latest commit contain support for DSTwo? (Even if you can't return it to its original state)
 

Site & Scene News

Popular threads in this forum

General chit-chat
Help Users
  • No one is chatting at the moment.
    Psionic Roshambo @ Psionic Roshambo: I did use a bot for Diablo III though but no ban there lol