The link is working just fine.404 on GitHub following latest release link in OP
Redownload the 0000000100D folder and place it in your sd card (sdmc/atmosphere/titles)Hi!
Any tip to get the HBL to load by pressing Album? It just reboots when I press it. It's 2.3 Switch so I might need to use the "legacy" way?
Clicking latest release under step 2?The link is working just fine.
I had to do some other steps. Load SXOS, boot Album, Update with ChonNX, then when it was on 6.2 Hekate worked fine.Redownload the 0000000100D folder and place it in your sd card (sdmc/atmosphere/titles)
Hi!
Any tip to get the HBL to load by pressing Album? It just reboots when I press it. It's 2.3 Switch so I might need to use the "legacy" way?
the icon is just the corrupted nsp you tried to install. you could try and reinstall it throught usb, and if it fails again you'll likely end up installing it throught the "traditional" way, by copying the nsp on your sdcard. This happened to me too, sighI tried installing an nsp with Goldtree through usb, and my switch instantly shutdown, what did I do wrong?
I rebooted and now I have a weird icon
Did it work for you? I couldn’t load more than 1 kip without the switch failing to boot?With reinx i load more kip. Thank for the reply. I'll try your Solution.
Sorry for me bad english
What exactly do you mean? When you launch the "CFW" options it tells you there is no "CFW"?When i boot hekate then try to boot cfw it says theres no cfw? do i need to provide one and put it somewhere? I'm trying to change from having reinx and i just took the latest files and replaced whatever was in my sd card.
Whatever you're trying to launch takes up too much RAM - Sysmodules have very very limited access to it so you can't really run that much at the same time.Did it work for you? I couldn’t load more than 1 kip without the switch failing to boot?
I tried installing an nsp with Goldtree through usb, and my switch instantly shutdown, what did I do wrong?
I rebooted and now I have a weird icon
The one to ask would probably be @XorTrollthe icon is just the corrupted nsp you tried to install. you could try and reinstall it throught usb, and if it fails again you'll likely end up installing it throught the "traditional" way, by copying the nsp on your sdcard. This happened to me too, sigh
ReiNX loads less of Atmosphere, this is a double sided sword as on the one hand it means that there is a (tiny) bit more RAM for sysmodules but on the other part vital parts of atmosphere aren't getting loaded - I still don't fully get what you're trying to load with such huge consumption as I would guess that most developers of sysmodules know that they are limited and hopefully don't take all of it but that's another thing
That's down to personal preference really. If you have a way of injecting payloads on hand, going the Hekate route is much more definitive. If not, holding the power button for 12 seconds in RCM will ensure it not only turns off but stays off.I want to try out the autorcm mode with hekate. Now my question is...how can i completely shutdown the console when autorcm is enabled? Should i hold the power button for 12 seconds when i'm in rcm mode or should i choose the power off option in the hekate bootloader? Sry for the bad english.
Ehm yes i haveIf you have a way of injecting payloads