I wanna chnage the payload but I don't know the default username or the default root password, does anyone have that info?
I get it, that most rpi aren't hot pluggable, but if you have everything wired up when you power up the pi, does it still give you problems?
If I can get that to run on a chip or an orange pi zero it would be cool. Those you could get really small with a printed case and cost a lot less
I'm not sure if there is a more convoluted way to launch an exploit.
Power bank is purely for portability. You could do some soldering on your RPi 3 to drop the USB Hub requirement, but no concerns.Is there a reason I need to use a power bank instead of just plugging it into the city power outlet? Also, I have an RPi 3, are there any additional concerns?
Must be a fat hack to make these names. :v
Rather than looping fusee-launcher.py, it would probably be better all round to add a udev rule that just runs fusee-launcher when the Switch's RCM USB VID/PID are detected.
Good job, im make similar IMG for my rpi but whit hotspot for change payload whit ssh and Phone and small dist whit raspbian lite (auto launch fuse on boot)
Whit my IMG yes can change payload vía wifi hotspot (sftp...no need state on my home whit router and rj45...)and poweron rpi whit OTG and Phone ,no need battery for poweron,and make more portable whitout batteryBut you can already connect to a hotspot and change payloads via ftp with this image and it boots on launch?