I'm also quite rusty. I'm running FW 11.0.0 Atmosphere 1.2.4) currently, trying to run ChoiDujourNX to upgrade to the latest version, but it's crashing when I'm trying to launch it.
I downloaded the latest ChoiDujourNX, the latest Atmosphere release, copied them over, also replaced the new fusee.bin and wondering what I'm doing wrong.
Not to bad mouth the program, but I've never had good luck with the AIO updater. I use it to download new FW, but updating AMS usually leads to an error for me.or download AIO Updater you can update everything without connecting your switch to PC
Not to bad mouth the program, but I've never had good luck with that program. I use it to download new FW, but updating AMS usually leads to an error for me.
I used to update with ChoiDujour in the past and run SXOS after, because it had a feature that Atsmosphere did not. I believe XCI loading or external hard drive support. One of the two, or both.ChiDujour is NOT FOR SXOS, is for Atmosphére, as far I know SXOS only works on older FW, your should try to boot atmosphére for be able to boot the new FW
If you have another SD card, you could try to format that to FAT32 and then boot atmosphere through that. If I recall correctly, ChoiDujourNX let you install the exFAT driver if you had the firmware files, perhaps Daybreak let's you do the sameNo doubt, the switch to Atmosphere is inevitable.
The only reason I kept using SXOS was due to some features it had that Atmosphere did not have at the time. I don't know if Atmosphere since got these features.
About my unbricking, the only thing I can do is load payloads through the SX dongle, I cannot boot into any firmware due to the from firmware format being installed.
If you have another SD card, you could try to format that to FAT32 and then boot atmosphere through that. If I recall correctly, ChoiDujourNX let you install the exFAT driver if you had the firmware files, perhaps Daybreak let's you do the same
Quoted straight from the release notes on the GitHub page:Hi, i wanted to update atmosphere but im currently using fusee primary, but now fusee primary is not available, so am i just going to replace fusee primary with fusee bin?? Because i use fusee primary to run my games, im kinda worry that it will effect my games
Please Note: various components were renamed (fusee-primary.bin -> fusee.bin, fusee-secondary.bin -> package3).
Alright thanks! I just wanted to make sure heheQuoted straight from the release notes on the GitHub page: