Search results

  1. E

    Tutorial Project How to set up ISFShax

    Ok, I tried a few things and got minute, isfshax and rednand running. The Wiiu lives! Not sure what did it. I had previously made the two sd card partitions for the MLC rebuild before trying to load up minute. This time I reformatted the sd as fat32 and got minute up and isfshax installed...
  2. E

    Tutorial Project How to set up ISFShax

    I have tried both launching fw.img and ios.img as boot1.img from the recovery menu. I tried the button presses you linked for minute above. What are the button presses for the isfshax installer? Thanks!
  3. E

    Tutorial Project How to set up ISFShax

    Picking up where JGSM left off as we seem to have the same issue. I tried renaming fw.img to boot1.img - got blinking blue led and no video. Waited a while then pushed power 15x and eject 1x. This seems to have booted the to the normal Wii menu. Restarting and booting just goes to the Wii...
  4. E

    Tutorial Project How to set up ISFShax

    Thanks for the continued help. I have renamed ios.img to boot1 and launched boot1 from the recovery menu. Video display drops out at this point and the led flashes blue. Nothing else seems to happen. For good measure I tried the installer button press sequence to see if it did the job...
  5. E

    Tutorial Project How to set up ISFShax

    Ok so if i do that you are then saying that installs isfshax from the recovery menu instead of minute? Dont i need minute for the rest of the install beyond isfshax (rednand / mlc rebuild etc)? How to do that if I can’t get minute going?
  6. E

    Tutorial Project How to set up ISFShax

    Sorry not following you. I have the ios.img, fw.img, superblock.img, superblock.img.sha and boot1.img all on the root as per the isfshax instructions.
  7. E

    Tutorial Project How to set up ISFShax

    So I got the video back to the tv by bypassing the AVR. Progress. However when I do load boot1 in the recovery menu the led flashes the goes purple and I still get no minute menu. The tv doesn’t detect a signal. I tried the blind button combination linked to launch the installer and it...
  8. E

    Tutorial Project How to set up ISFShax

    ok will try a few things. Wiiu is currently going through an AV receiver. Works fine when the Wiiu boots up, but in recovery it goes to the gamepad. So again will try to duplicate the one time when I got it going to the tv. Will run down gamepad or pull battery and also try connecting direct...
  9. E

    Tutorial Project How to set up ISFShax

    Looking further through the post history I seem to have the same issue as another person. The wiiu is outputting to the gamepad for the recovery menu, but sounds like minute needs hdmi. I have the wiiu hooked up to hdmi, but no video out put. Is there a way to force the output to hdmi? I...
  10. E

    Tutorial Project How to set up ISFShax

    Hi. Trying to follow these instructions, but when I get to load boot1 payload in UDPIH, nothing happens. I have the fw.img, not the one with “encrypted” in the filename. It just sits at the load boot1 payload screen, but doesn’t respond. Thoughts?
General chit-chat
Help Users
    BigOnYa @ BigOnYa: Que?