Search results

  1. Ring0man

    Picofly AIO Thread

    I have another flex cable I can use I'll try that.
  2. Ring0man

    Picofly AIO Thread

    Yeah, black screen. I'm sure the CPU still works since it's able to boot Hekate and do NAND dump operations but I'm kinda lost after that.
  3. Ring0man

    Picofly AIO Thread

    All were 47 ohms, 1 resistor. FW was the latest one. Nothing should be wrong EMMC wise, I did a full backup of the NAND and it didn't mention it being slower than normal or anything. It had to be a physical fault with the system I think, I remember I started the system with the modchip...
  4. Ring0man

    Picofly AIO Thread

    So in case anyone wants to help me figure this out, I've done some troubleshooting steps but I'm still stuck. Just to be clear, when booting CFW, OFW or even Ubuntu off the SD card, it can't boot into it. The Joycon logo does not appear when trying to boot, it's just a black screen. This tells...
  5. Ring0man

    Picofly AIO Thread

    Hi there! I installed my Picofly onto a new Switch Lite I bought. It boots to the Hekate screen no problem, but no matter what I try I can't boot into the actual console, not even OFW. I'm using all 40 awg magnet wire, a FAT 32 128 GB SD card, and the 47 ohm resistors on the DAT 0, CMD, and CLK...
  6. Ring0man

    Picofly AIO Thread

    Accidently burned off both copper pads on the CMD point for my Switch Lite. Any alternate points I can solder to?
General chit-chat
Help Users
  • No one is chatting at the moment.
    Psionic Roshambo @ Psionic Roshambo: https://youtu.be/PMCaXL2sGpc?si=jAKEK_yJL318jk17 lol