Search results

  1. BlueBeans

    PS5 UART commands

    mine ended up being the SSD controller after injecting voltage.
  2. BlueBeans

    PS5 UART commands

    PS5 Slim EDM-040. 5 second blod. Only short I found was at the location below. The two caps highlighted. Resistance was about 78 but on my working board shows around 125. UART codes below.
  3. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    Just when I thought all hope was lost. Had already told the customer the board was toast and then I figured out what was going on. I had cut through the CMD line when doing the kamikaze method! Holy hell! Another lesson in the books!
  4. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    So I just pulled the chip and I have a purple screen.
  5. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    I i unfortunately didn’t have a backup. I’m going to pull the mod. If it turns on it’s not the nand. Will update.
  6. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    Haven’t tried. Why?
  7. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    Yes I changed it even though it read as it should
  8. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    The resistor on the switch board or on the picofly ?
  9. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    When I tried to boot into ofw through hekate it said failed to initiate emmc. I didn’t try it yesterday. I’ll try when I get home. I’m 99% sure it’s dead but I don’t want to tell the customer until I’m 100% sure.
  10. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    I do not have an emmc reader nor did I try and do a back up. 1725941126 Just attempted a back up. No dice.
  11. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    Welp. I rebelled the nand, replaced all resistors, reflowed all the points, and I still get failed to initiate emmc. 😪
  12. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    Oh man. I got all the way done with the mod and as I was closing the lcd ribbon connector it snapped off. So I replaced it using what I thought was as little heat as possible. Go to create the emmc and I get this message. Did I fry it?
  13. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    So I was just thinking. I thought one of the benefits of doing the kamikaze method was that you don’t have to remove the board from the housing. So there must be an alternative RST point right?
  14. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    Holy hell I finally got it. After rearranging things a dozen times I finally put the mosfet on the front under the shield and it glitched immediately.
  15. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    I put 100ohm resistors in each spot. I could have sworn that’s what I was doing before (it’s been awhile since I’ve done one). When I get home from work I’ll switch it out for a 47ohm.
  16. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    So I’m currently working on an oled doing the kamakazi method. I keep getting =*** (emmc initial failure). I’ve cleaned everything and am getting the correct reading. Any help would be appreciated. Just checked and the switch still boots normal so I know I haven’t broken the trace. 1725590875...
  17. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    Alright. Got a little practice in on a dead board. Getting a better feel for it.
  18. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    I didn’t even know there was a back side dat0 kamakazi. Where is it at? 1722262960 Yeah I kept getting the correct value so I must have just pissed something off unfortunately. Will take it as a learning experience. I have two donor oled boards I’m going to practice on before I do another for real
  19. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    So my second Kamakazi was a bust. Think I was a little too confident and went right through dat0. Get a black screen now. Anyway to remedy it and use the original dat0 point?
  20. BlueBeans

    Hacking Hardware Picofly - a HWFLY switch modchip

    I didn’t take any but I have another one to do today and I will take some photos.